Crane Operation
Pendant Control
Slings
Hitches & Angles
Crane Inspection
100

The crane's capacity should be clearly marked on _______.

each side of the crane

100

Check all _________ for proper operation.

buttons

100

Rigging equipment should be inspected ___________.

before each shift

100

Slings must not be __________ with knots or bolts or other makeshift devices

shortened

100

Look for ___________ if the crane is binding or jumping.

bolts on the floor

200

________ must remain clear of loads about to be lifted and suspended.

Employees

200

Make sure that wire rope does not ________ when rewinding.

tangle

200

___________ must be proof-tested prior to use to 125 percent of its rated load

Custom lifting equipment

200
  • Slings used in a __________ must have the loads balanced to prevent slippage.

basket hitch

200
  • Operators must check for __________ at limits of trolley travel

trolley stops

300

Markings should be clearly legible from the ________.

ground

300

Buttons must return to ________ off when pressure is released.

"off"

300

When not in use, rigging equipment should be _______________.

removed from the immediate work area

300

The weight exerted on each sling in a two sling/90 degree hitch configuration carries __________ of a 1,000 lb load

500 lbs

300

Cranes should be inspected ________, and those inspections should be _________.

daily; documented

400

Crane operators should avoid sudden ___________ when moving suspended loads.

starts and stops

400

To test the _____________ , slowly run the hook all the way up to see if it stops.

upper limit switch

400

Slings must be ____________ from load sharp edges

padded or protected

400

The weight exerted on each sling in a two sling/45 degree hitch configuration carries __________ of a 1,000 lb load

707 lbs

400

___________ and __________ systems should be checked for leaks.

Air; hydraulic

500

_________ should be used unless their use creates an unsafe condition.

Tag lines

500

With the hook lowered all the way to the floor, at least __________ of wire must remain on the drum.

2 wraps

500

Chain sling inspection frequency depends on the __________ of service conditions, among other things.

severity

500

A _______ hitch is the strongest type of hitch.

basket

500

The throat of a hook should be enlarged no greater than _______.

15%

M
e
n
u