1
This gas is mixed with oxygen to create a flame that can cut through metal.
What is acetylene?
If you experience dizziness or lightheadedness while using an oxyacetylene torch, this is what you should do immediately.
What is stop working, turn off the gas, and get fresh air?
This device is used to ensure that the gases don't flow in the wrong direction, preventing flashbacks.
What is a flashback arrestor?
This is a potential hazard of using an oxyacetylene cutting torch that involves the torch's flame traveling back toward the regulators.
What is a flashback?
This is the maximum pressure setting for acetylene, which should not exceed this value to avoid an explosion.
What is 15 psi?
This safety device must be worn to protect your eyes from the intense light and heat produced by the cutting torch.
What is a Shade 5 goggles?
This is a critical item to have nearby when using an oxyacetylene cutting torch, in case of a fire emergency.
What is a fire extinguisher?
The proper flame for cutting metal should have this characteristic.
What is a neutral flame?
This must be done to the oxyacetylene hoses regularly to detect any potential leaks or damage.
What is inspecting the hoses for wear and tear?
In case of a fire caused by the cutting process, this is the first action you should take.
What is turning off the gas supply to the torch
Before lighting the torch, this is the first step you should always take to ensure safe operation.
What is checking for leaks in the hoses and connections
These protective gloves are necessary when handling the oxyacetylene torch to prevent burns from hot metal or sparks.
What are flame-resistant gloves?
This is the general rule for wearing protective gear while operating an oxyacetylene torch.
What is wearing flame-resistant clothing, gloves, and a helmet at all times?
When cutting, this is the safest distance between the torch and the workpiece to avoid an unsafe situation.
What is about 1/8 inch to 1/4 inch?
This tool should be used to adjust the flame to a specific cutting requirement.
What is the torch valve?
This piece of equipment controls the flow of oxygen and acetylene to the cutting torch and helps regulate the flame's temperature.
What is a regulator?
This is the proper method to light the oxyacetylene torch to avoid accidents.
What is lighting the torch with a striker, not a match or cigarette?
When you're done using the torch, this should be the last step to ensure safety
What is turning off the acetylene valve first, followed by the oxygen valve?
These should be stored separately to avoid the risk of a dangerous reaction.
What are oxygen and acetylene cylinders?
This is a safety precaution to follow when transporting oxyacetylene cylinders.
What is securing the cylinders in an upright position and using a valve protection cap?
You should never leave this open when not in use, as it could result in a dangerous gas leak.
What is the valve on the acetylene or oxygen tank?
You should always do this before adjusting the oxygen or acetylene regulators to ensure safe operation.
What is opening the cylinder valve slowly?
This gas is stored in a cylinder that should always be kept upright to avoid accidents.
This piece of equipment is used to control the size and shape of the flame produced by the torch.
What is the cutting tip?
When cutting metal, this action can cause a dangerous situation involving molten metal splashing.
What is holding the torch too close to the workpiece?