This is the delay between drilling a formation and seeing its cuttings and gas arrive at surface
What is lag time?
This rock type usually gives the highest gamma-ray readings because radioactive elements concentrate within it
What is shale?
The density log measures this formation property directly.
What is bulk density?
This type of gas show occurs because pumps are stopped, reducing ECD and allowing formation gas to enter the wellbore
What is connection gas?
Spectral gamma-ray logs separate total gamma ray into these three naturally radioactive components.
What are potassium (K), thorium (Th), and uranium (U)?
The neutron log primarily responds to the amount of this element in the formation.
What is hydrogen?
You notice the mud logger has made a comment about about an NCB on the log, likely referring to what?
What is a new core bit?
A reservoir interval has:
Low total gamma ray
Very high uranium
Low potassium
Low thorium
A geologist incorrectly classifies it as shale zone due to the GR spike reading from a standard gamma ray log. What would cause this mistake and how could it be remedied?
What is uranium enrichment causing a misleading gamma-ray response, requiring spectral GR interpretation to allow consideration of context? (Ex. migrating uranium enriched water, radioactive scale)
In a gas-bearing reservoir, the neutron log tends to read lower apparent porosity while this companion log tends to read higher apparent porosity.
What is the density log?
A zone shows elevated gas readings, but the cuttings consist mainly of unstable shale fragments originating higher in the hole - what are the name of these fragments?
What are cavings (or flakes)?
How can a resistivity logging run be modified or expanded to handle potential interference from larger than expected mud invasion?
What is trading off some resolution for a deeper penetrating log, or, using a second resistivity logging tool with deeper penetration.
A clean sandstone has a bulk density of 2.35 g/cc. Assume quartz matrix density of 2.65 g/cc and water density of 1.0 g/cc. Using the density porosity equation, determine the porosity.
What is approximately 18% porosity?
A mud logger reports bright blue-white fluorescence with little C4+ on the gas chromatograph - what fluid is this an indication of?
What is an indication of gas condensate (or a very light oil)?
Your GR log shows a constant and low reading in a zone, while your caliper indicates some reduction of the ID of your wellbore in this zone. Your density/neutron/resistivity logs indicate HC presence. Is the caliper reading a good or bad sign, and what does it indicate about the permeability of this reservoir section?
What is the caliper reading indicating mud-cake buildup in your sandstone, meaning you likely have clean sand with permeability high enough to allow for the invasion of the mud.
An interval shows:
How could you classify this reservoir?
What is a clean gas-bearing reservoir affected by density-neutron gas crossover and mud-filtrate invasion?