Constraints
Fusion
Adhesives
Fasteners
Grab Bag
100
Constrains two objects as they share a line
What is colinear?
100
Four figures included in the sketch panel of Fusion
What are lines, polygons, rectangles, circles, and ellipses?
100
This adhesive cures as water evaporates from it
What is white glue?
100
A fastener that requires a wrench for securing
What are nuts and bolts?
100
A countersink hole
What type of hole is used to prepare a surface for a screw?
200
Contrains a circle and another object so they touch at a single point
What is tangent?
200
The initial 2D command in Fusion after creating a component
What is create a new sketch?
200
An adhesive that uses resin to react with a hardener to form strong bonds
What is epoxy?
200
A fastener that is a slender metal shaft that is pointed at one end and flat at another
What is a nail?
200
Read the dial caliper shown.
What is 2.365 inches?
300
Constraint that sets the selected objects to be the same size
What is the equal constraint?
300
Fusion command that adds depth with an angle to a closed sketch profile
What is the extrude taper command?
300
A fast-setting strong adhesive to bond virtually any material.
What is Super Glue?
300
An inclined plane wrapped around a cylinder
What is a screw?
300
Identify the arrangement of drawings within a multiview technical drawing
What are
top isometric
front right?
400
Constrains the position of two points or a point and a line/curve together
What is coincident?
400
Fusion command that removes interior material
What is the shell command?
400
The water activated formula expands into materials to form an incredibly strong bond to virtually anything
What is polyurethane (gorilla® glue)?
400
An unthreaded fastener that is inserted through preformed holes
What is a pin?
400
When faced with choices in solutions, the simplest is most likely the best solution.
What is Occam's Razor?
500
Constrains two or more arcs, circles, ellipses to the same center point
What is concentric?
500
The Fusion command that allows the designer to bevel the edges of a solid surface or body
What is the chamfer command?
500
An adhesive sold as a solid; user must heat it to apply
What is hot melt glue?
500
The name of the catalog in Fusion for fasteners, adhesives, and other industry-standard components
What is McMaster-Carr?
500
A tool to objectively judge solutions based upon agreed upon criteria.
What is a decision matrix?