Materials & Tools
Joining
Safety
Pipe Sizing
Fittings
200

The most expensive water piping

What is Copper?

200

what is needed  to cut a piece of pex and crimp on a 90?

pex cutters, crimpers, crimp ring, and a crimp 90

200

Safety Glasses, steel toed boots, and hearing protection

What should you always wear when using a jackhammer?

200

When installing a new water system for a rough in what should be installed on the ends of water lines protruding out of the wall to supply a lavatory faucet or kitchen sink?

plugs

200

Which crimp fitting should be installed on a 3/4" trunk for a 1/2" branch serving a toilet water supply?

3/4" x 3/4" x 1/2" T

400

While cutting and threading pipes, you place the pipe on this tool.

What is a pipe stand?

400

If you ever have to use a sharkbite onto a copper line how should the pipe be prepped?

cut the pipe nice and square with thumbusters, clean with sandpaper, wipe off with a towel, then mark pipe the depth of sharkbite mouth, and slide fitting on until you hit the mark.

400

What should you wear when crawling under a home?

A crawl suit

400

What size water line would be run from the meter to a home with 7.5 bathrooms, 2 laundry areas, and a wet bar?

1"

400

if i come to the end of my hot water trunk and only have a 1/2" supply for the tub left, what fitting should i install?

3/4" x 1/2" reducer

600

Two main types of water piping used

PEX and Copper

600

what is needed to solder on a 90 degree elbow onto a stick of copper?

flux, solder, sand paper, and a torch

600

What should you wear when using a grinder?

hearing protection and safety glasses

600

What is the normal size of the water service line from the meter to the home of a house with 2.5 baths and a laundry?

3/4"

600

When ordering materials for a water re pipe with new shower valves what two things will be needed for a tub?

Rough in Valve with tub spout and a drop ear 90

800

Creates sparks to ignite the propane torch with a piece of flint.

What is a striker?

800

what is needed to prep a threaded piece of pipe into a 90?

two pipe wrenches, thread tape, and dope

800

What should be worn when excavating rock?

gloves, safety glasses, and hearing protection

800
What is the minimum size water line that should be run to supply and exit a water heater?

3/4"

800
When installing a new water system, what fitting would need to be installed to provide water to a fridge?

fridge box

1000

Name three different methods of installing pex fittings

expansion, crimp, and shark bite

1000

What valve is installed onto the water system to control the incoming pressure into a home?

A Pressure Reducing Valve
1000

what should be worn when running plumbing through an attic with old insulation?

crawl suit and breathing respirator

1000

What is the minimum sized water line that should be run to a toilet?

1/2"

1000

When installing a new water system what would be needed to supply water and drain to a washer and dryer?

Washer Box

M
e
n
u