1
WHICH SECTION ALLOWS FOR THE EXPANSION OF THE HOT GASSES?
COMBUSTION
WHICH TYPE OF ATTACHMENT TO THE DISK IS USED FOR TURBINE BLADES?
FIR TREE
WHICH PART OF THE EXHAUST SYSTEM CREATES A DIVERGENT SHAPE?
CONE
Newton's third law is known as the law of?
Action
Which type alloy cannot be used in the hot section?
Titanium
WHAT TYPE OF IGNITION SYSTEM DOES A TURBINE ENGINE HAVE?
HIGH ENERGY CAPACITOR DISCHARGE SYSTEM
THE LENGTHENING OF A TURBINE ROTOR BLADE IS CALLED?
CREEP
WHAT PERCENT OF RATED THRUST IS PROVIDED BY THE THRUST REVERSERS?
AT LEAST 50%
Newton's second law is known as the law of?
Acceleration
What process can extend the life of a metal part?
Laser peening
WHICH TYPE COMBUSTION CHAMBER IS THE MOST EFFICIENT?
ANNULAR
THE TAIL PIPE IS PART OF WHAT SECTION?
EXHAUST SYSTEM
Who was known as the "Father of the Gas Turbine Engine?
Frank Whittle
What is the process of plating for turbine parts?
Metal coating sprayed
What can you not use to shot peen a part?
Sand
WHICH SECTION TRANSFORMS A PORTION OF THE KINETIC ENERGY IN THE HOT GASSES INTO MECHANICAL ENERGY?
TURBINE
WHAT ARE THE THREE PARTS OF THE TURBINE ENGINE EXHAUST SYSTEM?
CONE, NOZZLE & TAILPIPE
Who dreamed of flying to the moon but instead Blew himself up?
WAN HU
What type material is coated for Hot section parts?
Ceramic
What is finishing?
Base material is protected with a desired treatment
WHAT ARE THE BASIC ELEMENTS OF AN AXIAL FLOW TURBINE?
NOZZLE DIAPHRAGM, SHROUD & ROTOR
WHAT COMPONENT SUPPORTS THE EXHAUST CONE?
EXIT GUIDE VANES & NOZZLE
Mass is measured in what units?
lbs./sec
How do you stress relief metal surfaces?
Heated slowly then cooled at a specific rate
In a combustion chamber what creates a cooling blanket?
Secondary air