QAP 1
When visually inspecting system red and green, this could cause "sputtering" from the application bar
What is
Imbalance air in chemistry, dirty versadial filters, incorrectly packed tuffy pads
___ amount of foam remains on the glass and paint as it approaches the next friction application
What is
moderate
This is supposed to cause residual foam to break down on paint and glass from
What is
System Yellow
This chemical application should have consistent fill out between driver’s side and passenger’s side
What is
Wheel Polish
As final rinse hits, there is an _________ ______ with rapid beading
What is
Immediate break
This chemical turns off at the top of every windshield
What is
Fresh Scent
After first friction wheels/tires have ______ __ __left on their surfaces
What is
Little to no
Water beads _____ and _______ streams down glass
What is
Immediately and rapidly
Titanium 360 Solution contacting vehicle has this type of beading
What is
Milky
(will also accept fast break)
This is where the water first beads and peels back on the paint and glass without flat sheeting
What is
The flash blowers
This is the chemical that should have a thin white foam stay on until first friction
What is
System Silver
Should the top brush spin the direction of the vehicle or against it?
against it to create better cleaning action. This adds more friction which helps break up bugs, dirt and grime.
Thin or limited foam on car as it approaches the
What is
The Hotshine pan
This application should have little to no sudsiness and helps safeguard against road dirt, bugs and grime.
What is
Platinum Repel Shield/ Platinum Protectant
Droplets have
What is
Short tails or no tails
The color order of the T3 LEDs
what is
blue, red, amber
What are 3 common issues that can cause Hotshine not to form a full waterfall application?
dirty tuffys, incorrect number of tuffys, build up on ramp, dirty applicator bar
Water starts to bead on windshield and Water starts to bead on hood with
What is
Top Omni
Very little ____ remains as vehicle exits the final top friction
What is
Foam
Inspecting water movement at the blowers the droplet size is relatively consistent and slightly
What is
Larger
This is where the drying process begins
What is
The drying process starts at the beginning of the tunnel, with your high PH chemicals.
The first application of chemical
when assessing wash quality, what should we look for after 1st top friction cleaning, before approaching next friction application?
moderate amount of foam remains on vehicle.
System Yellow causes foam to ____ ____ and ____ _____ of ____ from glass
What is
Thin out and Clear Patches of Foam
treatment that targets long term wheel protection rather than immediate cleaning
Wheel Polish
Inspecting tire shine there are no ____ or ___ ________ that may cause sling
What is
Buildups or hot spots