Get Bend
For an unequal legged fillet weld, the size of the weld is determined by ____.
The shorter of the two leg lengths.
Page 19
What is a SCWI?
Senior Certified Welding Inspector.
Page 9
What is the most common non-destructive method used to detect sub-surface volumetric discontinuities in welds?
Radiographic Testing (RT)
Page 72
Who oversees the coordination of work across multiple areas and ensures saftey protocols are followed?
Lead Hand
Page 25
Name the three types of guided bend tests.
Root-Bends, Face-Bends, Side-Bends.
Page 52
Which section of codes, standards, and specifications provides workmanship tolerances in assembled groove weld joints and weld groove prepartion?
(List AWS & CSA)
AWS D1.1 & CSA W59
Page 15
What are the two basic types of penetrants used in LPI?
Visible Dye and Fluorescent Dye
Page 67
Who is responsible for overseeing inventory control?
(As per the textbook)
Shop Manager
(In smaller settings, the welding supervisor and the shop manager may be the same person)
Page 26
In relation to destructive or non-destructive testing, what does "UTS" stand for?
Ultimate Tensile Strength
Page 56
PT is based on the ability of the penetrating liquid to be drawn into a discontinuity through what action?
Capillary Action
Page 66
What is an IQI?
Image Quality Indicator.
Page 73
A welding supervisor should have a minimum of ____ years of welding related experience.
(As per the textbook)
Minimum of five years of welding related experience.
Page 26
What is a sniffer?
A helium detection instrument.
(used in leak tests)
Page 80
What test is an easy method for determining material hardness?
File Test
Page 85
On a Welder qualification card what does "progression" refer to?
Welding Position
Page 29
When conducting an ET, how would the results be displayed?
Cathode Ray Tube (CRT) Screen.
Page 78
Codes, standards, and specifications provide tolerances for misalignment (offset) in parts to be groove welded. CSA W59 allows a maximum misalignment of ____ when backing bars are being used.
Only 2mm (1/16 inch).
Page 10
What are the 3 sides of the "Quality Triangle" that should be verified by the weld inspector prior to beginning any welding?
Approved welding procedures, Correct Materials, and Qualified Welders.
Page 28
Where might "HICC" occur?
In the weld metal -In the Haz -In any orientation with respect to the weld axis.
Page 47
What type of guided bend test jig is normally used for aluminium?
Wrap-Around guided bend test jig.
Page 51
What is the Vickers Pyramid Number (HV)?
HV = 1.854 P/d2
Page 84
What is the typical dwell time for penetrant to be drawn into discontinuities?
Typical dwell time ranges between 5 and 30 minutes.
Page 68 mf
For parts that are 75mm (3 Inches) thick or greater, what is the maximum gap provided that a suitable backing material is used to prevent melt-through?
8mm (5/16 inch)
Page 13
CSA W47.1. Calls for a maximum bead size of 6.4mm (1/4 inch) and a weld length of 50mm (2 inches) for what type of test?
Fillet Weld Break Test.
Page 62
Who defines quality as "getting something right the first time, every time, at an acceptable cost"
Other Sources
Page 6