Cage Loading
How should you zip tie a piece of metal over 50lbs?
Lying flat in the cage
What should you verify after counting parts during a blind count?
Verify all part numbers are correct
Look through the tote and verify part numbers
How to test if a scratch is damage worthy on a bumper?
What is a scratch test (When your fingernail catches the scratch)
Where does plastic go in a cage?
What is cage net
What key do you hit to flag a location?
What is F10
When you have an old label on a part where do you put the new one?
Above the old label
How should bumpers be placed in a location
On car position (facing the way of equipment travel)
How many dealer parts should be handled at a time while taking parts to the cage?
what is one dealer at a time
At what point should you scan the part during the picking process?
Once it's on the module
How do you know whether or not to open up a 10 pack?
Check your quantity on the screen and label
How many bumpers per branch on a bumper tree?
What is 2
How many windshield bars are supposed to be used for a windshield?
What is 1
What test should you do to see if a headlamp is damaged?
What is shake test Shake test
If you find a random small part on the floor, where should you take it?
To the red cart in DA isle
What should you do when a panel is poking out the box?
Put an inspection label on the part and drop it off at the power lane
How high can each stack of rotors go in a cage?
What is 5
What should you look for when picking molding tubes?
Tape on both ends of the tube
At what point is a tote deemed over weighted?
Over 50lbs
What is the most common damage for panels?
Dents/Bends