Leadership
Willing to go forward under difficult circumstances
What is courage?
Standing or raising of hands is this type of vote
What is visual
removes slag, and wire brush removes rust and dirt.
What is chipping hammer?
Metal that does NOT contain IRON
What is non-ferrous?
is done by heating to a cherry red heat and plunging the metal in water or oil if high carbon steel
What is hardening?
placing the desires and welfare of others above yourself
what is unselfishness?
Calling on each person individually to give their vote
what is roll call?
The maximum pressure for acetylene should be ______ pounds per square inch.
What is 15?
method used to make round holes in cold metal using drills and metal cutting bits.
What is drilling?
heating metal to the proper temperature and then slowly cooling it to soften and toughen hardened or tempered steel.
What is annealing?
reliable support for an individual, group or cause.
what is loyalty?
Survivor style of voting (writing down to cast your vote)
What is ballot?
used to catch the molten metal to prevent fire hazards and to keep the concrete floor from chipping.
What is metal container?
procedure used to sharpen points or edges of cutting tools made of high carbon steel.
What is grinding?
Soldering a copper pipe into a copper pipe fitting is called?
What is "sweating a joint"?
think through, determine procedures.
What is plan?
Speaking to vote
What is voice vote?
What should not be used for an oxy torch to light it?
What is match or lighter?
used to mark metal to make a permanent mark
What is an awl?
When cutting carbon steel, one should hold the cutting tip ____ยบ to the metal.
What is 90?
saying or doing the right thing without offending.
What is tact?
Book of parliamentary authority by Henry M. Robert that serves as the basis for parliamentary law
What is roberts rule of order?
hold metal in place for welding
What is clamp?
used to lubricate the tools to keep them from overheating and from becoming dull.
What is cutting oil?
What type of flame is best for heating, cutting, and welding?
What is neutral?