Status Display Area
Binary
Slow Down
Logic
The Key, Please
100
Has symbols that represent JOINT or RECTANGULAR, etc.
What is Coordinate Systems?
100
Binary for 33.
What is 00100001?
100
These notes from the programmer can appear either in a stand-alone line or as a tag on another command line.
What is COMMENT?
100
Used to go to another job and then return to the parent
What is CALL?
100
Key used to trigger UNDO / REDO feature
What is ASSIST key?
200
Has settings like Inching, Low, Medium, etc.
What is Manual Speed?
200
10000001 in Base 10
What is 129?
200
This instruction acts as a momentary contact switch for the Universal Outputs. Time can vary from.3 seconds up to 655.35 seconds.
What is PULSE?
200
Command line that controls the line of code where the controller jumps to
What is *LABEL?
200
Key that triggers access to non-motion commands
What is INFORM LIST?
300
Has settings like Hold Status, Emergency Stop Status.
What is State Under Execution?
300
The highest base 10 number that can be displayed in an 8 digit byte.
What is 255?
300
This instruction causes a delay in the execution of the job for a specified period.
What is TIMER?
300
This command allows one to go to another job but does not return automatically to the parent job.
What is JUMP JOB?
300
The key used to access the Detailed Edit Screen
What is SELECT?
400
One of the settings in the Operations Cycle indicator
What is Step or Cycle or Continuous?
400
Binary for 205.
What is 11001101?
400
This instruction causes the robot to suspend operation until either a timer or input condition is met
What is WAIT?
400
By placing the *LABEL command earlier in the job than the JUMP *LABEL command, the robot will do this
What is loop?
400
Used to begin execution of a job
What is START?
500
The indicator has four squares with two lines in each
What is Multi-Window?
500
11101110 in Base 10
What is 238?
500
This command will cause the robot to stop execution of the job until the START button is pushed again.
What is PAUSE?
500
This tag allows for the main command execution only when a certain input is present
What is a CONDITIONAL IF?
500
Two keys used to manually set a Universal Output
What is INTERLOCK + SELECT?
M
e
n
u