A
Refers to the entire Machine that applies strapping to the rolls
Roll Bander or Bander
welding heads
when shutting down roll bander after a run, you use this to shutdown the machine.
bar that comes down in the wrapper to seal the 2 sheets of film together around the product?
Seal Bar
this indicates that you are running out of stretch wrap
low film alarm
Dancing Bar
the gate that closes to allow two or three rolls to accumulate before releasing them into the bander
pop up gate
this tool will be used to splice together banding
Hand strapper
this person ensures the correct film is running and the rolls are getting packaged correctly
production associates
this pre compresses the mat before entering the triangle
pre compression unit
a piece of equipment that finished rolls enter into in order to separate the rolls into individual pieces using a combination of conveyor speed and bend between the angle conveyors
Roll Breaker
the bar on the roll Badner that drops down to keep the rolls from pulling back into the bander before the welding heads move in to weld and cut the strapping
tension bar
when cleaning the welding head with supplied air gun, blow air into bottom of head from the back, but NEVER do this?
Blow air into the front of the welding head
Machine that uses a crane to move the plastic overwrap film?
Hoist
this function to cycle the machine with no product in the machine
dry cycle
shaft that goes through the core of the film and is used to hold film into place
air bar
person responsible for the safe operation of the roll bander
Production associates
these must be adjusted as close to the width of the rolls as possible?
side infeed guide
This component controls the diameter of the roll
pressure roller
system that checks the orientation of the bag and tells the machine if it needs to be flipped, let through or kicked off
vision system
equipment on the conveyor system, that moves when in auto to send the rolls to the machine that is ready for it, or the belt that is ready for it
Diverter
right at the exit of the oven the area that cools off the plastic film and rolls it smooth around the product
Cooling Tower
the correct way to lift a roll of film into shrink wrapper
double wrap choke hitch
use this to control the back belt conveyor speed?
curve speed incline belt setting
moves set of bags into place and sends them to compression chamber
collator