Air Supply Unit
Brake Application
General Knowledge
200

Vent air from the high-pressure stage when the ASU stops, preventing motor overload when the ASU restarts.

What is the High-Capacity Vent Valve?

200

I convert pneumatic braking into hydraulic braking, amplifying pressures by 11-12 times.

What is the HP-4 Actuator?

200

Mounted to the wheel, you cannot stop the train without me.

What is the Brake Disc/Rotor?

400

Consisting of 2 parts, I conserve angular momentum and absorb some of the vibrations created by the compressor.

What is the Flexable Coupling and Flywheel?

400

No friction required! I am the system that slows the train down above about 15 mph.

What is the Propulsion System?

400

Peek-a-boo. I'm under door #9 and I see you.

What is the A-1 Brake Pipe Unit?

600

I'll pop off at 60 psi if something goes wrong.

What is the Low-Pressure Cylinder Safety Valve?

600

Below 1/2 inch I am considered "no good".

What are Brake Pads?

600

AW0 

What is the ready-to-run weight, or the weight of the car without the passengers ?

800

Spring loaded body that shows an orange collar if the filters are clogged.

What is the Vacuum Indicator?

800

I am the only manually applied and relased brake application on Legacy Trains.

What is the Parking Brake?

800

Pressure differential between front and rear BC pressure causing White Light Fault

What is 20 PSI?

1000

Clean, Cooled, Dry, and Compressed.

What are the 4 characteristics of supplied air?

1000

I am instrumental in the application of the brakes, but I never get to the brakes themselves.

What is Brake Cylinder Control Pressure?

1000

15-37-26-48

What is the proper torque sequence for a brake disc?

M
e
n
u