Outstanding in your field
Ready..Steady...GO!
Where am I going?
Where am I?
misc
100
This IPv4 header field is always set to 0100 for IPv4
What is version?
100
The first step in the router boot process, this step uses athe built-in ROM chip to perform a hardware check.
What is performing POST
100
This command on a Cisco IOS router is used to display the routing table.
What is show IP route
100
This is the type of memory where the IOS files of the router are stored.
What is Flash
100
Command you would use to save changes made to the router configuration so that it will be used automatically the next time that the router reboots?
What is copy run start
200
This IPv4 header field is commonly referred to as a hop count.
What is Time-to-Live
200
The second step in the router boot process, this is when the IOS is located.
What is loading bootstrap
200
This is the letter found on the routing table that indicates that the network is directly connected to the router.
What is c
200
This is the type of router memory where the firmware is stored that performs POST
What is ROM
200
Identifies end devices in network layer communication
What is an IP address
300
This IPv4 header field identifies the IP address of the sending host.
What is source IP
300
The third step in the router boot process, this is when the IOS is loaded into RAM after the Bootstrap finds the IOS file to be used
What is Load the IOS
300
Refer to the example..... this identifies the IP address of the next router to forward the packet.
What is 209.165.200.226
300
This is the type of router memory where the ARP and Routing tables are stored.
What is RAM
300
Three things a device must be configured with in order to communicate across multiple networks.
What is IP address, subnet mask, default gateway
400
This IPv4 header field identifies the upper-layer protocol to be used next.
What is protocol
400
The fourth step in the router boot process, this is when the file from NVRAM, a TFTP server or Setup Mode is loaded into RAM.
What is loading the configuration file
400
Refer to the example.... this identifies the exit interface to use to forward a packet toward the final destination.
What is Serial0/0/0
400
This is the type of router memory where the startup configuration file is stored
What is NVRAM
400
Three characteristics of the IP protocol
What is connectionless, best effort, media independent
500
This IPv4 header field identifies the priority of each packet.
What is differentiated services.
500
This is what POST stands for.
What is Power On Self Test.
500
Refer to the example... This identifies the trustworthiness of the router source.
What is administrative distance (90).
500
This is the type of router memory that stores the running configuration and the packet buffer
What is RAM
500
This command displays a summary chart of all router interfaces, their IP addresses, and their current operational status?
What is show ip interface brief
M
e
n
u