PPE
Emergency Procedures
Hazard Identification
Machine Safety
General Safety
100

What is a hard hat used for?

What is It Protects your head from falling objects

100

Where do you go in a plant evacuation?

What is parking lot B

100

What is a common slip hazard?

What is paper, ice, strap etc..

100

What is a machine guard?

What is A device that protects the operator from moving parts

100

Why is it important to keep your work area clean?

What is To prevent slips/trips, cuts.  etc...

200

Name two types of eye protection.

What are Safety glasses and face shields

200

What should you do if you find a chemical spill?

What is dial *70, listen for the prompts for a Spill.  

200

What should you do if you see a frayed wire?

What is call an electrician and put in a service order

200

Why is Lockout/tagout important?

What is it Prevents accidental startup of machinery.

200

What should you do if you see an unsafe act?  

What is to Talk to the employee, show them another way to do the task safely.   Report it to a supervisor.

300

When should you wear hearing protection?

What is when you are on the production floor. 

300

How do you use a fire extinguisher?

What is Pull the Pin   Aim the extinguisher at the base of the fire  Squeeze the handle.   Sweep the base of the fire.

300

What does it mean for a guard to be secured?

What is all hardware is in place.   If there are four holes for bolts there must be 4 bolts in place. 

300

What should you do before operating your machine?

What is do a walk around and ensure all guards/safeties are in place and operational.
300

Why is it important to report safety opportunities?

To prevent future incidents.  

400

What type of jewelry can be worn at work? 

What is stud earrings only.  Anything else must be approved by the leaves department.
400
When do you call the Fire Dept.?  

What is If two extinguishers are used and the fire is not out

400

If you put a chemical in a spray bottle what else must also be on the bottle?  

What is a chemical label

400

Name a common machine related injury.

What are cuts or caught in injuries 

400

What is the purpose of a safety audit?

To identify and correct safety opportunities before an incident occurs.  

500

Name two types of gloves and when they should be worn.

What is  Nitrile gloves - anytime using chemicals and cut resistant gloves anytime you are handling sharp objects.

500

What do you do if someone is injured?

What is page a code blue. 

500

What should you do everyday before using a big joe?

What is the Pre-Use inspection

500

What is the purpose of an emergency "Stop" button?

What is to quickly stop the equipment in an emergency situation.

500

What is something you can do before starting a new task?

What is Take 4 seconds to think about how you can do the task as safely as possible.

M
e
n
u