This is the final confirmation step in the LTT process.
What is the TRY step?
This is the speed forklifts should be governed at.
What is 7 MPH?
This is what is needed when walking in a forklift traffic area.
What is a high-visibility vest & radio communication?
This is where the mustering point is located for evacuations.
What is the northeast (back left) corner of the parking lot?
This is when any safety incident or concern should be reported.
What is immediately, no less than 24 hours?
This is used when LTT extends beyond a single shift.
What are departmental locks?
This is the AI detection system installed on all forklift.
What is the Omni-Pro system?
This device requires a pedestrian to slow down, stop, and look both ways before crossing an intersection.
What is a swing gate?
This device is used to notify the plant to take shelter.
What is an emergency air horn?
This tag applies for the following scenario:
Wet laminator conduit & hoses run across the floor, creating a trip hazard.
What is a yellow tag?
This is the total number of electrical isolation points found on the diagram.
What is 4?
This is the minimum distance a pedestrian can approach a forklift.
What is 3 feet?
This work area has a respirator protection requirement.
What is the CNC machine area?
This reference helps workers understand where the closest emergency exit is in relation to their work area.
What are evacuation maps?
This report applies for the following scenario:
Forklift operator tips over pallets near a pedestrian aisleway without causing injury.
What is a near miss report?
This must be done before locking out P1 to ensure stored energy is controlled and the hazard is eliminated.
What is blocking the cutting foot with a wooden block?
This is who has the right-of-way at an intersection between a forklift and a pedestrian.
What is neither the forklift driver nor the pedestrian has the right-of-way?
This is where used hydraulic oil and rags must be disposed.
What is a used oil drum?
These are the proper steps to use a fire extinguisher, also known as P.A.S.S.
What is pull the pin, aim the nozzle, squeeze the trigger, and sweep at the base of the fire?
This tag applies for the following scenario:
Lift assist has an air leak that needs repaired.
What is a red tag?
These are the lockout points for "Cleaning the Machine".
What are E1 & P1, with CG1, CG2, M1, & M2 callouts?
This term describes the balance of a forklift, representing the invisible zone created by three points of suspension.

What is the stability triangle?
These are the two main forms of universal waste disposed of by the Columbus team.
What are aerosol cans and batteries?
This type of fire extinguisher is used at the site.
What is an ABC fire extinguisher?
This is the OSHA form known as the "Log of Work-Related Injuring and Illnesses".
What is OSHA Form 300?