General Safety
This small box contains items used to clean cuts and wash out your eyes.
First-Aid Kit.
The recommended angle for a ladder to ensure proper stability.
75 Degrees.
What is the purpose of trauma straps?
Allows the worker, who is suspended, to stand up in their harness and to relieve the pressure being applied to the arteries and veins around the top of the legs
True or False: If a blade is dull, it is acceptable to use the utility knife without gloves.
False. Always wear cut-resistant gloves prior to using a utility knife or handling any sharp objects.
What is LOTO and why is it important?
Lockout Tagout ensures dangerous equipment is de-energized and cannot re-energize unexpectedly.
True or false? I can set a ladder going from the 1st story roof to the 2nd story roof as long as the top of the ladder is properly secured.
False. The bottom of the ladder must also be secured to the roof with Velcro straps.
Two key points to remember when ascending and descending a ladder.
1. Maintain three points of contact.
2. Keep your body within the center of the ladder.
True or False? A properly fitted harness is when:
True! All three are correct.
When using a blade to open a box, the correct way to cut is...
A) Away from the body.
B) Toward the body.
C) With a lot of pressure.
D) With a quick flick of the wrist.
A) Away from the body.
Daisy Chain.
It can lead to overloaded circuits and fire risk.
Person responsible for ensuring the Site Safety Plan is accurate and communicates any hazards with all employees on site.
Fall competent person.
True or False. It is okay to use a metal ladder when working in close proximity to electricity.
False. Never use a metal ladder when working near electricity. A fiber glass ladder should be utilized.
You are painting conduit from a ladder 6 feet above the ground. There are installers working on the roof above. What PPE do you need in order to establish safe work conditions?
Full body harness, tied off to anchor and rope, hard hat, gloves, and safety glasses..
Yes or No: Is it safe to hand your co-worker a utility knife with the blade pointed toward their hand?
No, never hand a utility knife with the blade pointed at someone's hand. Instead, hand the knife so the receiver grabs it by the handle and always wear gloves.
An electrical safety device that senses small imbalances in the circuit caused by current leakage to ground, and in a fraction of a second, shuts off the electricity.
GFI/GFCI - Ground Fault Circuit Interrupter
This Bolt form is used to identify hazards associated with the job and must be submitted before beginning work.
Job Hazard Analysis (JHA).
True or False. It is acceptable to exceed a ladder's weight limit by a few pounds.
False. Never exceed a ladder's weight limit. A fall resulting in serious bodily injury can occur.
When work is complete, and all workers have left the roof, the ____________ removes lifelines and anchors, making sure to properly flash all penetrations.
Last Man Down/Last Person Down
When selecting a utility knife, it's best to use one with a ________ blade.
Retractable.
True or False. If an employee is working near a service drop, they do not need to cover it with an orange electrical mat.
False! An employee must always place an orange electrical mat over a service drop when working near it.
This yellow roll of tape is used to establish a ________ ______ ____ that is drawn out on the site safety plan.
Restricted Access Zone (RAZ).
What is a foot apart, touches the bottom of your shoe, and should be held on to when ascending and descending a ladder?
Rungs.
Please demonstrate how to tie a proper figure-8 knot.
Looks great! Points awarded!
Please demonstrate how to correctly open a box with a utility knife.
Perfect form! Points awarded!
If a dead front is removed, the main breaker is shut off, and no one is around, is an employee required to wear their electrical PPE?
Yes. If the utility meter has not been removed, even if the main breaker is shut off, an employee is required to wear their arc suit while working in the main panel.