Energized Systems
Lifting Operations
Falls
Human & Machine Interface
Line of Fire
100
All equipment is required to be what prior to maintenance operations?
What is Locked & Tagged out?
100
What must be established and communicated to prevent unauthorized personnel from entering hazardous lifting areas?
What are controlled access/exclusion zones?
100
At what height is fall protection required at BMS?
What is 4ft.
100
What role is essential to assist equipment operators in congested or high noise areas to prevent accidents?
What is a trained spotter?
100
Who shall be in place to inspect the load for stability and any shifting that may have taken place during transit and to observe all unloading activities ?
What is a designated competent person?
200
What is a critical step before working near energized systems?
What is identifying and de-energizing or isolating the system
200
What is this Rigging Violation?
What is only hardware that is in compliance with ANSI requirements will be permitted on site.
200
What safety PPE equipment is commonly used to protect workers from falls?
What is a Personal Fall Arrest System (PFAS)
200
What safety measure is recommended if a spotter must leave the area during equipment operation?
What is stopping the task until the spotter is replaced or no longer needed?
200
What Line of Fire Hazard is Present in this photo?
What is Guard missing on table saw?
300
Name a potential hazard from energized systems besides electrical shock?
What are fires, explosions, or flying objects from system failure?
300
When lifting with a forklift or material handler under the forks what must be used?
What is an engineered lifting attachment must be used.
300
What is the purpose of a Fall Rescue Plan in construction safety?
What is to safely retrieve a person who has fallen and is suspended in a safety harness
300
All workers must make eye contact with operators when walking within ______ of equipment or vehicles.
What is 25 feet
300
What Line of Fire Hazard is Present Here?
Unattended/loaded powder actuated tool. OSHA FINE (OSHA fines for leaving out Hilti strips can range from $16,550 to $165,514 )
400
What Electrical hazards are present in this photo?
What is missing (NRTL) approved (e.g., UL) covers are required on all panels, load centers, pull boxes, etc. prior to energizing. Equipment shall be secured to prevent unauthorized/unqualified workers access to energized electrical parts or equipment.
400
Multiple slings in the body of a shackle will not exceed what angle?
What is 120 Degrees?
400
What is the hazard in this photo?
What is the back D-ring should be centered between the shoulder blades.
400
All Heavy Equipment and trucks (___ or larger) shall be equipped with an effective warning device that operates automatically when the vehicle is backing.
What is 1 Ton
400
What line of fire hazard is present in this photo?
What is no controlled access zone present?
500
What should be done to reduce the volume of tests and isolate systems during pressure testing?
What is isolating the system to create separation between tested systems and those not under test?
500
Purchased lifting device must be stamped with what?
What is maximum working load limit and manufacturer's name?
500
What fall protection hazard is identified here?
What is - incorrect height & incorrect clip numbers/spacing
500
Overhead utility line proximity safe work procedures include what clearance for how many feet: Over 50 to 200 kV – 15’ clearance
What is – 15’ clearance
500
What is the line of fire hazard?
What is gas cylinder not secured?