Bandsaw
A _______________ is used for re-sawing on a band saw.
pivot block
The size of a table saw is determined by the:
Blade diameter
What machine is used to make two surfaces parallel?
Planer
What machine will best make 1 edge and 1 surface square and clean?
Jointer
Changing router bits must only take place when the ___________________.
router is unplugged from the power outlet
The blade guard on a band saw should be adjusted__________.
to within ¼” of the stock
When using dado cutters on the table saw, the table insert must be replaced with a special _____.
Throat Plate
When milling rough sawn boards on a single-sided Planer or Surfacer, the machine _______.
will not remove warp from a board
Which way does the grain go on the jointer?
With the Grain
The function of a pilot or bearing on a router bit is to ___________.
Follow a contour
The ___________ is located behind the blade and prevents the blade from deflecting when the stock is pushed into the blade.
thrust bearing
Ripping narrow stock on the table saw requires:
a splitter or riving knife, guard, fence and push stick
What is a consideration before milling a board on a Planer?
Grain direction is correctly identified
What part of a jointer is kept in a fixed height position for all standard operations?
Outfeed Table
What is the dimension tolerance for a Rabbet milled with a Portable Router?
1/64"
What is the dimension tolerance for Freehand Ripping One Edge on the Band Saw?
+1/16”, -0
What is a consideration before attempting to rip (long stock) on a Table Saw?
Stock is supported at out-feed
Warp in solid stock is removed by a:
Jointer
Jointing against the grain of a board will most likely result in _____________.
Chipped Grain
If one needed a rabbet on a board and had a straight bit in the router, what would you need?
A straight fence with a cut-out for the bit is needed
Describe where the saw guides are located on a band saw: (3 descriptions)
Both sides and behind the blade, above and below the table
A dado head cannot cut:
Mortises
The lower feed rolls on the planer can be set higher to ______________.
improve the ability to feed
To get a 1/16” depth and a 3 degree bevel using the jointer, what needs to be adjusted? (2 things)
infeed table and fence
What is a consideration when using a Portable Router?
Router bit pointed away from body after completion of cut