DRILLS/DRILL NORMS/BITS
This bit has a center point that must be in contact with the material for a clean cut.
Forstner Bit
NUMBER ONE RULE OF THE SHOP!
DON'T BE STUPID
A straight edge that goes 12 inches in one direction also has a side for centimeters.
Ruler
A metal hammer should be used for what
Metal objects like nails only.
The higher grit the sandpaper the more what is the result?
The finer the result.
Which bit has a cylindrical shaft and a inclined plane. This drill can cause tear out.
Twist bit
PART THAT IS ABOVE THE WOOD WHEN CUTTING ON A SAW?
THE BLADE GUARD
Clamp that uses springs to lock itself in place
Spring clamp
A mallet is used to enhance objects like
A chisel
Is a band or scroll saw easier to make small detailed cuts with?
Scroll saw
Clamp the piece down
SHOULD A UNPLUGGED MACHINE BE USED?
NO
A ruler with a 90 degree angle, that can be used for marking angles, a straight edge and knocking off debris.
Carpenter's square
The type of mallet used to fit pieces of wood together and that offers lots/a decent bit of bounce back
Rubber mallet
On a band saw what height should the guard be at?
1/8"-1/4"
The smaller hole that makes sure the wood doesn't split the material.
Pilot hole
HOW MANY PEOPLE CAN OPERATE A MACHINE AT ONCE?
1
A speed or F clamp
The type of mallet used to drive pieces of wood into another such as a dowel into a design.
Wooden mallet
The saw used to cut very large complete pieces of plywood into smaller more usable pieces?
Vertical Panel Saw
The machine that requires the mandrel to have the pins locked in place. This is also used to make many uniform holes quickly.
Drill Press
WHAT SHOULD NEVER BE USED AS A CLAMP!
What is used to tell whether or not a object is circular and the center of it. In a moment of need this can also be used as a straight edge.
Centering Square
Type of hammer used when no reverberation is wanted. Also has a inner metal core.
Dead blow hammer
Disc, Belt, and Spindle