S
In natural fall, all lengths in the solid form fall to the same?
Level
which projection angle is used to sculpt the uniformly layered form?
90 degrees
the projection angle of the stationary design line is most important because it establishes the location to which all other lengths are
converged
the area below the occipital is referred to as the
nape
the direction the hair is combed in relation to its base parting is called?
distribution
What shape is the uniformly layered form?
Circular/Rounded
What can cause a graduated appearance to occur over the ear when sculpting solid forms?
Tension
when sculpting uniformly layered lengths the design line should remain?
visible
the area all around the hairline is referred to as the
perimeter
parallel and nonparallel
What is the surface texture of the solid form?
Unactivated
Where is the longest lengths in the uniform?
the 7 sculpting procedures are section, head position, part, distribute, project, finger/shear position and
design line
which head position procedures lengths that are shorter in the nape and longer surface lengths creating an under bevel effect?
forward
An uneven effect is created when cutting hair that is?
partly wet and partly dry
Stationary
conversion layering is the most common cutting technique used to create?
increase layered forms
how many sections does the most common sectioning pattern divide the hair into?
4
when performing a hair sculpture what determines the size of the parting?
density
which tool is used to create a clean blunt edge?
Shears
The distribution used to sculpt solid form is
natural distribution
mobile
top
Lines that curve outward, like the outside of a sphere are called?
convex
the movable blade of the shears is controlled by the?
DOUBLE POINTS!!!!!!!
thumb grip