Drill press
How do you tighten the drill press?
Chuck key
The minimum length you can cut is?
12 inches
Where should you hold the blade until it comes to a complete stop?
Down
What must you wear at all times in the shop?
Safety Glasses
What way should the teeth be pointing?
Downwards
How should you hold stock securely?
Clamp
How should lumber be fed into the planer?
With the grain
What should you always do to the stock?
Clamp it
What must you do before entering the shop?
put up hair, take off jewelry, secure baggy clothing
Do you ever back out of a cut?
No
How should material be removed?
Shop Brush/Vac
How many boards can be cut at one time?
One
How far should hands stay from the bland when cutting?
6 inches
What is not allowed in the shop?
Horseplay
What is the process of splitting wood into multiple pieces?
Re-sawing
How do you select a drill bit?
Size, sharpness, and shank
What is the purpose of the off-bearer?
Support, pull, and move stock as it comes through
What is the purpose of a trial cut?
To see if saw is cutting and set correctly
Why do you take time when doing work?
To prevent mistakes, injuries, equipment damage, and a bad project
When do you know if the blade is dull?
If too much cutting pressure has to be applied to make a cut
What is the hazard present after drilling?
Sharp edges around hole
Maximum amount of cut allowed at one time is?
1/16 inch
What is the purpose of a stop block?
Improve cut accuracy and save time
What do you wear when handling hot material?
Gloves
What should you do to prevent binding on sharp curves?
Relief cuts