Band saw
The danger zone for the band saw is?
To the right of the operator's position.
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger
When operating the drill press, what should be done with long hair?
Tie it back close to your head and keep your head away from moving parts.
A student is permitted to leave the laboratory only ________.
with the instructor’s permission
There is danger of kickback if you use the _______ spinning side of the disc?
upward
While operating the band saw, it is safe practice to _________?
maintain a balanced stance at all times
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
Which item of protective equipment is absolutely necessary when operating drill press?
Safety glasses
Students should never ________ while working in the laboratory.
shout
Hold the stock ________ as it is being sanded?
steady
Avoid _______ of a cut?
backing out
Where should the saw arm and blade be positioned when cutting is complete and the operator is leaving the work zone?
Reset to 90 degrees on all gauges and left up with all guards intact and the trigger off
What type of drill press chuck should be used with a straight shank twist drill?
Jocobs chuck
__________ should not be worn in the Tech Lab unless you are handling hot material.
Gloves
Cut ______ to the line, this reduces the amount needed to sand off?
Close
If the blade breaks on the band saw, shut off the power and ______?
Move away quickly
Besides safety glasses and closed toed shoes, what personal protective equipment should be worn when operating the motorized miter saw?
Hearing protection
Stock chips and curls should be removed from drill the drill press?
By using a brush
Approved safety glasses or goggles must be worn _________.
at all times in the shop
Once you have fininshed using a machine wait until all moving parts have ______ before leaving the machine?
stopped
The correct blade width to use for a specific job depends on ________?
The radius of the cut
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ____________
see if the saw is cutting properly and is set accurately
If the stock being drilled begins to revolve, you should?
Turn off the drill press and free the stock.
At the end of class, the laboratory should be ___________.
cleaned and all tools returned to their proper place
Keep hands and fingers at least ____ inches from all moving parts on any machine?
Four