Shop Safety
What is required to be worn in the shop?
Safety Glasses
The best time to remove scrap material from the band saw is?
when the saw stops
Make sure you use the ______________ width of the belt.
Entire
Which item(s) of protective equipment is/are absolutely necessary when operating the drill press?
Safety glasses
Besides safety glasses and closed toed shoes, what personal protective equipment should be worn when operating the motorized miter saw?
Hearing protection
What should you not do in the shop?
Horse play and other distracting behavers
If the blade breaks on the band saw, shut off the power and?
move away quickly
Cut ___________to the line, this reduces the amount needed to sand off.
Close
Which is not a safe way to secure stock while it is being drilled?
Hold it firmly by hand, but securely on the drill press table
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Hold it in the down position
What kind of shoes should you wear in the shop?
Close toe shoes
There is very little what when using a band saw?
kickback
Keep hands and fingers at least _____________________ inches from all moving parts on any machine.
Four
When operating the drill press, what should be done with long hair?
Tie it back close to your head and keep your head away from moving parts
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
Why should you not wear jewelry in the shop?
It can get caught in machinery
When you give work your individual attention, you?
concentrate on the work at hand
Hold the stock ______________________ as it is being sanded.
Steady
Which should be done while drilling stock with the drill press?
Maintain enough feed pressure to keep the bit cutting at all times
What special protection must be observed when using the motorized miter saw outside?
Connect the saw to a ground fault circuit interrupter (GFCI)
Before the guest enters the shop you should?
Offer them safety glasses
The blade on the band saw should be installed with the teeth pointing?
downward for cutting both softwood and hardwood
If a fire happens to break out on the sander, try to unplug it but don’t get hurt in the process. Make sure you _____________ ____________ and then notify the instructor.
Back Away
What type of drill press chuck should be used with a straight shank twist drill?
Jacobs chuck
The purpose of a "stop block" when making multiple cuts with the motorized miter saw is to ____________
improve cut accuracy and reduce the time required to make multiple cuts