General Safety
What do you need to have on in the Shop?
Safety Glasses
If your fingers are close to the blade what must you use?
Push stick
When using the disc Sander do you go upward or downward.
What should you do with the stock?
Clamp it down
Always do what when your done with the scroll Saw?
Turn the Saw off and unplug the Saw.
What type of shoes should you have?
Closed toed Shoes
Should your hand be in line with the blade? True or false
False
how many people should be using the machine at once?
1
Never put your finger in line with what?
The blade.
Should you leave the Saw with the light on.
No
What should you not do in the Shop?
Horseplay
How many inches away should your hands be from the blade?
3 to 4 inches away.
Should you have the stock in the air when sanding.
No it should be on the table.
Whats the point of the stop block
To get accurate and correct cuts.
What are relief cuts for?
To cut curves easier without the blade binding.
what not to do when someones using a machine?
Distract them
If you hear clicking in the machine what should you do?
Turn it off and check the blade
What should you turn one before the Sander?
The dust collector.
You should hold the Saw in the ____ position when done cutting.
Down.
How do you check the tension of the blade.
By flicking it and if it rings its tight enough.
what is the Workshop dresscode? 4 answers
No baggy clothes, Tuck in Strings, Tie long hair, Roll in sleeves
what do you do when backing out of a cut?
Turn off machine and wait until the blaid completely stops. Then remove wood.
What is the purpose of removing the belt guard?
So you can sand curved pieces.
Where should you put your hands.
Out of line with the blade to the side 6 inches away.
What do you do if the blade breaks.
Notify the instructor.