General safety
The student should notify the instructor immediately in case of _________.
accident, injury, defective equipment or tools
When operating the drill press, what should be done with long hair?
Tie it back close to your head and keep your head away from moving parts
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Hold it in the down position
There is danger of kickback if you use the __________ spinning side of the disc
Upward
The blade on the band saw should be installed with the teeth pointing _________.
Downward
A student is permitted to leave the laboratory only ________.
with the instructor’s permission
What type of drill press chuck should be used with a straight shank twist drill?
Jacobs chuck
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
Hold the stock ______________________ as it is being sanded.
Steady
After turning the machine off, ___________________________ before walking away.
lower the blade guard
Students should not rush laboratory work because it may lead to _________.
damage to equipment, poor project quality, accidents and injury
If the stock being drilled begins to revolve, you should _________.
turn off the drill press and free the stock
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger
Make sure you use the ______________ width of the belt.
Entire
There is little danger of _________________ on the bandsaw.
Kickback
Approved safety glasses or goggles must be worn _________.
at all times in the shop
Before turning on the drill press the operator should _________.
tighten the drill press table locking clamp, clamp work in a vise, remove the chuck key
Where should the saw blade be aligned when making a cut with the motorized miter saw?
Always on the waste side of the line
Use the machine's ___________________ to hold the stock while sanding. Do not hold it freely in your hands.
Table
To prevent the blade from binding in sharp curves, ______________ cuts should be made.
Relief
Approved safety glasses can be identified by ___________.
the Z 87.1 logo and manufacturer’s emblem
Stock chips and curls should be removed from the drill press _________.
by using a brush
What special protection must be observed when using the motorized miter saw outside?
Connect the saw to a ground fault circuit interrupter (GFCI)
Cut ___________to the line, this reduces the amount needed to sand off.
Close
When sawing small stock, you should always use a ___________.
Push stick