Misc1
Mills
Lathe
Decimals
Misc2
100

________ screwdrivers are used in a wide variety of assembly applications such as automobile assemblies and cutting tool mounting applications.

Torx

100

________ requires the crank handle to be rotated to orient the indexing head spindle.

Simple indexing

100

The sliding motion of the saddle is parallel to the ways and is called ________ feed.

Longitudinal

100

What is 5/16 in decimal form?

0.3125

100

________ diameter is important for achieving a desired thread fit and is a standardized dimension directly referenced from a chart.

Pitch

100

The advantage of the ________ protractor is that it is smaller and flatter, and this can enable angle layout in places that other protractors cannot.

Plain

100

The ________ allows movement from left to right along the X-axis on a mill.

Table

100

Performing a ________ operation on the lathe uses a special narrow tool to cut off the end workpiece at a desired length.

Parting

100

What is 3/8 in decimal form?

0.375

100

_________are often responsible for measuring sizes to ensure parts meet specifications shown on engineering drawings.

Operators

100

________ are vital to cool moving parts, minimize friction between them, and prevent their seizing.

Lubricants

100

End mills can be properly held in the machine spindle with a________.

Stub arbor

100

The ________ is a very long threaded rod supported by bearings at both ends. It spans the length of the ways and provides motion for thread cutting.

Leadscrew

100

What is 1/8 in decimal form?

0.125

100

When a pedestal grinder wheel surface becomes uneven, it should be __________________.

Dressed

100

If a broken tap is somewhat intact, a tap ________ may be able to be used to remove it from the hole.

Extractor

100

Knee-type milling machines often use IPR for power quill feed settings, but power feeds for the table and saddle are specified in ______.

IPM

100

________ is an operation that cuts across the end of a workpiece to machine the end flat.

Facing

100

What is 13/16 in decimal form?

0.8125

100

The side across from any given angle is called the _______ side.

Opposite

100

A ________ is a hybrid between a square and a protractor.

Die maker's square

100

The ________ endmill is an endmill with a half-round sphere ground on its end.

Ballnose

100

The ________ taper in the lathe tailstock quill can be used for mounting taper-shank holemaking tools.

Morse

100

What is 1/16 in decimal form?

0.0625

100

________ refers to the movement, or advancement, of the cutting tool into the workpiece.

Feed

M
e
n
u