Basic Hand Tools
Threaded Fasteners
4-Stroke Cycle
Engine Parts ID
Disassembly
100
What is a Phillips Screwdriver?
100
A spiral ridge wrapped around a cylinder to create a helix, part of a bolt or screw.
What is a Thread
100
The Stroke in which the engine "Breathes" in the Air-Fuel mixture.
What is the Intake Stroke
100
What is the Piston
100
This part needed to be held to keep it from rotating when taking the nut off that was holding it on
What is the Flywheel
200
What is a Ball Peen Hammer
200
Threaded Fasteners can be in the form of Bolts, Nuts and …..
What are Screws
200
The Stroke in which air is forced out of the engine.
What is the Exhaust Stroke
200
What is the Engine Block
200
A tool used during diagnosis to test the percentage of cylinder ________
What is Leakage
300
What is a Box End Wrench
300
The Measurement shown as D
What is Diameter
300
This happens after the Exhaust stroke
What is the Intake Stroke
300
What is the Crank Shaft
300
Part of the Camshaft and Crankshaft gears used to set the engine timing.
What are Timing Marks
400
What is a Slip Joint Pliers
400
Used to mark metal or wood with a divot, allows lining up drill-bits with ease.
What is a Center Punch
400
This strokes purpose is to increase the cylinder pressure containing fuel and air, to prepare for ignition.
What is the Compression Stroke
400
What is the Camshaft
400
Fastened to the gas tank, used to deliver air and fuel into the engine
What is the Carburetor
500
%2C445%2C291%2C400%2C400%2Carial%2C12%2C4%2C0%2C0%2C5_SCLZZZZZZZ_.jpg)
What is a Ratchet
500
A Tap is used to put _______ into a hole in a piece of metal.
What are Threads
500
The Stroke in which an explosion happens inside of the cylinder and forces the piston down.
What is the Power Stroke
500
What is the Tappet
500
The two types of Piston Rings are ….
What are the Compression Rings and Oil Control Ring