Tools
The part of the pliers that should sit on the top of the glass when breaking it at a score line
How to prevent glass shards from entering your eye when cutting and grinding
what are safety glasses?
A way of cutting the glass that will cause it to break randomly
What is sharp angles OR not cutting edge to edge?
The chemical we use make the solder melt and flow easily
What is flux?
What is patina?
The type of mark a glass cutter leaves on the glass
What is a score line?
The reason we wash our hands after handling solder
What is lead?
The side of the glass you should cut on
What is the smooth side?
The process of putting a thin coating of solder around the edge foil of a project.
What is tinning?
What we do after finishing our project to preserve and protect it
What is waxing?
What tool do we use to cut solder off the spool
What is the soldering iron?
What we wear to keep solder from splashing on us
What is an apron?
What we write on our glass so if we lose a piece it can be found again
What are initials?
The process of attaching your project together when you first start soldering
What is tacking?
The patina that must be applied with a toothbrush
What is copper patina?
The purpose of the fume extractors
What are the solder gasses?
The chemical we should wipe up after using the soldering stations
What is flux?
This type of glass is manufactured with the colors
What is modern stained glass?
The side of the copper foil you should look at while foiling
What is the black adhesive side?
The phrase we use for edge finishing our piece
What is "Chop & dab"?
The tool we use to make sure our project is set up at a 90 degree angle before soldering
What is a set square
What to do with long hair while grinding glass
What is pull back/put behind shoulders?
This type of glass is stained with pigments then fired to create the colors
What is TRUE stained glass?
The process of smoothing the foil onto a glass piece using a sharpie or other plastic tool
What is burnishing?
Where you should handle the final project to avoid fingerprints
What is the edges/sides of the project?