Components
Front and Rear Suspension
styles
Dampers
Springs
Alignments
100
This connect a control arm to the frame or subframe
what is a bushing
100
the abbreviation for upper lower control arm
what is SLA
100
What on of the main functions of a damper
to control the motion of the spring
100
this spring can be made up of multiple pieces of semi flat steel
what is a leaf spring
100
this angle is the difference between the front and rear edge of the tires and when the front edge is closer then the rear it is
what is positive Toe
200
what connect the control arm to the knuckle
what is a ball joint
200
the upper part of the strut pivots on this
what is the upper strut mount
200
in which direction does the damper have more resistance
What is rebound
200
what are the circular ends of a leaf spring called 
the eye the spring
200
this is when the top of the tires lean outward
positive camber
300
what limits body roll
what is the sway bay/stabilizer bar
300
This have no upper control arm and the spring in NOT mounted on the strut
what is Modified McPherson strut
300
The gas that a shock is charged with
What is Nitrogen
300
what is the most common spring found in cars today
what are coil springs
300
this angle is viewed from the side and is made up from the lower ball joint and the upper ball joint or strut mount
what is caster
400
what connects the sway bar to the knuckle or strut
what is an end link
400
Both rear wheel are rigidly attached
what is a solid axle
400
How does a damper control ride height
It doesn't
400
this bolt holds the spring together and locates the spring on the axle

what is the center bolt

400
2.5 caster on the left and 2.0 caster on the right
what will pull to the rigth
500
This is a part of the knuckle the outer tie rod mounts to and is set at a specific angle
what is the steering arm
500
This is not full independent but does allow one tire to move more freely because of it inverted U channel
What is semi independent
500
a damper with a 70/30 damping ratio means what
what is more resistance to rebound then compression
500
what are the different spring rate a spring can be made with
linear/strait rate, progressive
500
the steering axis view from the front
what is SAI
M
e
n
u