Other
What has to be done to the hoist in order for it to be safe?
Put the locks on.
How many pistons are in the engine?
1.
What component supplys fuel to the engine?
Carburettor.
Intake Specification?
0.10-0.15
What tool is used to check the valve clearance?
Feeler gauges
Where is the spark plug tester located?
Green tool box.
What does the engine position need to be at to check the valves?
TDC compression stroke.
What component is used to check the oil?
Dip stick
Exhaust Specification?
0.15-0.20
What type of socket is used to take the spark plug out?
A spark plug socket.
What does HP stand for?
Horsepower.
How many bolts come off the side cover?
What component is located between the muffler and Air filter?
Spark plug.
What is the spark plug gap specification?
0.7-0.8mm
What tool is used to put the piston back in the cylinder?
Piston ring compressor.
What does the cabinet beside the white board do?
Controls the power.
What is the first step to be able to check the valves?
Taking the 4 bolts off the valve cover.
What component is located between the crank shaft and piston?
Cam shaft.
How many times should you pull over the engine when checking compression?
Pull it over 5 times
What tool is used to check the thread pitch?
Thread pitch gauges.
What causes low compression?
Worn piston rings
What is the part number on the side of the engine?
DH212
What component travels up and down in the cylinder.
Piston
what is the correct clearance for the ignition coil.
A business card or 0.010
What size socket is used to take off the muffler?
13mm socket