Rocketry
General Safety
Band Saw
Drill Press
Sanders
100
The main reason you attach fins to your rocket
What is Stability
100
All of these should be cleaned up immediately
What are Spills
100
These are made before cutting a circle
What are relief cuts
100
By backing out of deep cuts you are preventing this.
What is Overheating
100
This machine only sands concave circles.
What is a Spindle Sander
200
Small straw attached to side of rocket
What is Launch Lug
200
These should be worn at all times
What are Safety Glasses
200
Tool required and needed to cut cylindrical stock
What is a V-Block
200
This tightens the bit into the drill press.
What is the Chuck Key
200
Do not use the Disk Sander on Concave circles, but on these instead.
What are Convex
300
Elastic String
What is shock cord
300
When Carried, these should be done so pointed toward the ground.
What are sharp-edged tools?
300
Immediately turn off and get teacher if this happens
What is the blade breakes
300
This should be placed under the piece being drilled through.
What is Scrap
300
When using all sanders all materials must be secured against this
What is the Table
400
Strings that attach parachute to rocket.
What are Shroud lines
400
Use this to clean off machines and benches.
What is a brush
400
The danger zone is located here
What is the right-hand side
400
Never stop this part by hand
What is the Chuck
400
This happens when sanding in one spot.
What is Wear or Burining
500
Name 3 of the 4 friends depicted in October Sky
Homer, Quentin, O'Dell, Roy Lee
500
Do not disturb these until they are finished.
What are students
500
The guard should be set at this
What is 1/8th to 1/4th of an inch above the thickness of a board
500
Use this at all times when using a drill press
What is a Clamp
500
When using a Belt Sander or a Disk Sander, sand on the side going in this direction.
What is Downward
M
e
n
u