MPWC
Error code 0206 on MPWC indicates an error between these 2 sensors
What is PSC6 and PSC7?
When replacing the Power Supply Box (SUBCPU Box,) This Module must be removed as the first step
What is the Card Receipt Module?
These 3 configuration types of the TC have an A4 Statement printer included in the MHMI-20
What is the C3, D3 and E3
The capacity of the line escrow
What is 30 checks?
Error code 8401 on the MRCW indicates a failure in this motor
The outlet capacity for coin rolls with a 25mm diameter
What is 15 rolls?
Error code 3210 on the SUBCPU indicates an issue with this solenoid
What is SDC21?
Error 120B for the MHMI-10 indicates this issue
What is shutter failure?
DOUBLE JEOPARDY!!
These are the periodic replacement parts for the MCPM
What is the Gate Roller/Gate Roller ASSY (and ink cartridge) ?
The part number for the shaft that holds the Dispense Transport Unit in place
What is VQ60G1200Y0?
The RAS recognition sensor adjustment procedure must be performed anytime one of these 4 units are replaced
What is Angle sensor, MG sensor, Transport Unit, and CPU+IO board?
DOUBLE JEOPARDY!!
This is the color, and number of spacers required per position on the GLR Cassette Height Guide A/F/G for US notes (66~67mm)
What is 2 blue spacers?
This part number will need to be ordered if the Rear Monitor Support Staff is lost
What is X710H9E00Y0?
The Cartridge life of the Endorsement Printer Ink Cartridge
What is approximately 1 million characters or 6 months after opening?
The CPU-C Board on the MRCW receives power from this component
What is Relay Board ( or Power Supply Unit)?
Setting of the date/time on MPWC can be done with this RAS command
What is 5101?
The IO-Self Board on the GLR is powered by this component
What is the UMC board?
The A4 document printer communicates via to USB to this component
What is the PC?
This part will need to be ordered if the site loses their STACKER and RETRACT BOX keys
What is X701Y0400Y0?
DOUBLE JEOPARDY!!
When performing a Sensor Dust Check, this is the Sensor No. Code for sensor PSB01T Sort gate 1 timing detection
What is 05?
When installing software via CF card, this is the Dip Switch setting change that must be performed
What is DSW3 switched to bit 1 on, bit 2 off, bit 3 on, and bit 4 off?
The PcBord (PRS Board) is the home of these two DLL drivers
What is Device DLL and BV DLL?
Installation of MHMI-20C1(Box) is required on these 3 TC configurations
What is C1, D1, and E1?
When replacing the GCPM Main Board, these 5 software adjustment procedures must be performed
What is Parameter initialization, Sensor Calibration, CIS Calibration, MICR Gain Adjustment, and Ink Reset?
When any stacker has a request for 5 or more coins, this is the order the stackers dispense from
What is 5, 6, 7, 8, 1, 2, 3, 4?