safety
engine
measurement
tools
misc
100
what does osha stand for
What is occupational safety and health administration
100
the flywheel weights gives this to the engine to help keep it running
What is momentum
100
how is a metric bolt measured for thread pitch
What is the millimeters between each thread
100
this tool is used mostly to removed stripped or stubborn Phillips head screws along with others that may apply
What is an impact driver
100
this connects the engine to the rear wheels
What is a final drive
200
these are the type of fire extinguishers that are found in the shop
What is abc type
200
a four stoke crankshaft rotates how many times to complete a full cycle
What is 2 times
200
valve springs should be measured with what tool.
What is digital/ vernier caliper
200
removes broken bolts. may required extra help with heat and penetrant but bolt may require drilling if this fails.
What is a screw extractor
200
1/4x20- 1 1/2 what is the tread pitch of this sae bolt.
What is 20 tpi
300
lift with your
What is your Legs
300
the part of the engine that's below the cylinder is referred to as what
What is lower/bottom end
300
a metric micrometer has what increments on the thimble
What is .01mm
300
describe a service or technical bulletin
helps the tech stay up to date with factory related issues related to the service, parts dept and new models.
300
a heli coil is used to
What is replace treads to original size and increase strength
400
loose fitting attire and________ shouldn't be worn while in the shop.
What is chain wallets
400
when both valves are open for a split moment during normal operation
What is valve overlap
400
write .0012"
What is twelve ten thousandths of an inch
400
this tool removes brake fluid using compressed air
What is vacula
400
the tool used to zero a micrometer
What is a standard
500
hydrogen is dangerous and is produced by doing this everyday procedure
What is charging a battery
500
this opens and closes the intake port sometimes on a two stroke
What is the piston
500
a t gauge is accurate and reliable
What is not
500
used to measure dept. od. and id.
What is venier/ digital caliper
500
the owners manual is used to look up specs and procedures
What is service manual
M
e
n
u