Light Off
Max JPT Temp on light off
887 deg F (475 dec C)
How much fuel should go into the T-10B fuel tank
18,000 gallons
The max JPT C accepted during performance at 110.2NL% C @ ambient temp 60 Deg.F
687 C
What is the publications for the deckplates (TYPE XIII) torque specs.
NAVAIR 17-1-537
What NL% do you record water flow during water injection checkout.
104.5 NL%
Thrust Delta should read between _____ lbs when engine is shut down.
0.0 lb - +20lbs
how long should demin water stay in the demin tank before its considered bad
24 hours
Minimum acceptance corrected thrust (LB) during performance @ ambient temp 60 Deg.F
21550 LBS
what publication do we use to hang an engine
A1-F402B-MMI-230
A1-F402B-TPS-000
1.4-1.6 seconds
Hot engine start cycle is performed when JPT is _____ or more.
302 deg F (150 deg. C)
how much fuel filters does the T-10B facillity have
3
normal oil pressure at 102.5 % NL RPM
45-55
what is the hose and tubes manual
01-1A-20
During hot Reslam acceleration checkout:
"increase engine speed to ___ NL% and run engine for ___ minute(s)"
103.6% NL,
1 Minute
If fuel valves wont open. What is the most likely problem.
Doors are not sealed
how much FCVs does the T-10B have for all its applicable systems (fuel/preservation/water)
4
Maximum SFC at 16280 lb horizontal thrust
0.677 lb/lb thrust/hr (for fuel of 10167 CHU/lb)
What publications are used while doing a fuel sample
COMNAVAIRFORNIST 4790.2C chapter 10.2.3.2
NAVAIR 00.80T-109
NAVAIR 01-1A-35
The difference between the maximum the minimum channel reading for T4 TEMP and T7 TEMP, respectively, shall not exceed __.
30 DEG. F.
After an aborted start cycle, perform the following...
1) Wait one minute
2) Perform Dry Motoring Cycle
3) Repeat start cycle
What are the wind limits for the T-10B for each section
Sector 1: 16 MPH
Sector 2: no limits
Sector 3: 5 MPH
What is the Max corrected NH (percent) during 110.2% NL C performance on a normal day
97.0%
What is the publication to Pre Op the T-10 and T-36
AG-JETIS-POM-000
What is the corrective action if DECU fault checkout shows DEC8.
REPLACE DECU