Compound Miter Saw
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger
Which item of protective equipment is absolutely necessary when operating the drill press?
Safety glasses
Once you have finished using a machine wait until all moving parts have _________________ before leaving the machine.
Stopped
Avoid ____________ of a cut.
Backing out
The student should notify the instructor immediately in case of _________.
Injury, accident, Defective equipment or tools.
Hands or fingers should never come closer than ___________ to the rotating blade when operating the motorized miter saw
4 inches
To select the proper drill bit, one should check _________.
size, sharpness and type of shank
Hold the stock ______________________ as it is being sanded.
Steady
Which of the following is the correct procedure to determine if the blade is operating on the middle of the band saw wheel?
Turn the wheel by hand to check
Students should never ________ while working in the laboratory.
Shout
The purpose of a "stop block" when making multiple cuts with the motorized miter saw is to ____________
improve cut accuracy and reduce the time required to make multiple cuts
Should you hold your stock firmly by hand, but securely on the drill press table ?
NO!
Cut ___________to the line, this reduces the amount needed to sand off.
Close
The best time to remove scrap material from the band saw is ___________.
stopped
The “yellow” color coding system refers to __________.
Caution
What special protection must be observed when using the motorized miter saw outside?
Connect the saw to a ground fault circuit interrupter (GFCI)
When operating the drill press, what should be done with long hair?
Tie it back close to your head and keep your head away from moving parts
Use the machine's ___________________ to hold the stock while sanding. Do not hold it freely in your hands.
Table.
The blade on the band saw should be installed with the teeth pointing _________.
downward for cutting both softwood and hardwood
If a visitor comes into the mechanics laboratory, one should:
issue them a pair of safety glasses
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
What type of drill press chuck should be used with a straight shank twist drill?
Jacobs chuck
There is danger of kickback if you use the __________ spinning side of the disc
Upward
If it is necessary to back the blade out of a cut, __________.
turn the power off and then free the blade.
Approved safety glasses can be identified by ___________.
the Z 87.1 logo and manufacturer’s emblem