GENERAL RULES/PPE
Theses, when installed, shall be used in all vehicles and equipment.
Seat belts.
Compressors should have a drain valve at the lowest point. The air receiver tank should be drained this often.
Daily.
Tools should be maintained in good condition and inspected this often.
Daily.
As a spotter for a piece of equipment, establish and maintain clear visual contact with the driver in this mirror.
Left rear view mirror.
Skid loader operators shall were the following protective equipment. (4 items)
Safety hard hat
Safety glasses
Hearing protection
Safety footwear
Footwear must conform to this amount of compression and impact
75 pounds.
Compressed air used for the purpose of cleaning parts must be nozzle-regulated to this PSI maximum discharge pressure.
30
When striking metal against metal, this type of protection shall be worn.
Safety eye protection.
When should a spotter verbally communicate any hazards to the driver.
Before backing.
When moving a Gradall or excavator keep the attachments approximately this many inches above ground level.
15 inches.
These two safety items shall be worn at propane refueling stations.
Eye protection and rubber insulated gloves.
Air pressure gauges shall be rated this amount over the normal operating pressure to reduce fatigue on the pressure gauge.
Twice
A minimum of this many load binders and chains shall be used to secure trailer loads.
4 chains
4 binders
This type of backing is prohibited.
Blind backing.
All equipment with the rear vision permanently obstructed will have this.
Backup alarm.
Where this word is used, it is considered to be an advisable usage, recommended but not mandatory.
Should
Hearing protection shall be worn while the air compressor is operating, if the employee is working withing this distance of the compressor.
5 feet.
Do this to chisels prior to use in very cold weather.
Warm.
Articulating machines should always have this relieved prior to operator departing cab.
Hydraulic pressure.
Chipper operators shall were these two types of hearing protection.
Ear plugs with ear muffs.
Only this type of safety hat accessories shall be used while working in areas where employees are subject to electrical shock.
Dielectric
Air tool operators shall wear the following protective equipment: (3 items)
Safety eye wear
Safety footwear
Hearing protection
This type of safety equipment shall be worn when using a machete.
Safety goggles.
When deadheading a front-end loader, the bucket should be positioned no higher than this many inches off the road.
18 inches.
A current this for any herbicide that may be present in the tank must be carried in the truck at all times.
SDS (Safety Data Sheet)