Roller Set
An elongated curvature shape with parallel C-lines, consisting of a closed end and an open end is referred to as a(n)
Oblong
The hair between the scalp and the first turn of the hair around the roller, thermal iron or round brush is called the stem, also known as the:
Arc
Rectangle shapes are usually used to move hair:
In one direction
The direction the hair is combed or dispersed over the curve of the head is referred to as:
Distributing
The half-circle is most often used to move the hair half toward, half away from the ______.
Face
In which of the following hair design techniques is a small section of hair held taut with one hand, while the other hand slides the brush from ends to the base?
Backbrushing
In hair design, what type of roller is used within straight shapes to create uniform curls?
Straight or Cylinder rollers
The overall direction of a hair design can be analyzed according to where the hair moves in relation to the:
face
Molding refers to designing wet hair in straight or curved lines to create a pattern and is also known as:
Shaping
Holding the hair 90° from the center of the base and having the tool sit half-off and half-on the bottom parting results from which type of base control?
Half Off
The five finishing procedures include, relax, dry mold, backcomb/backbrush, define the form and:
Detail
Hair that is held at a 45° angle above the center of the base and rolled to sit in the upper portion of the base, but not on or above the parting can be described as:
Overdirected
Using a hand-held dryer while simultaneously using the fingers to style the hair is an example of ___________ designing.
Thermal
In hair design, straight shapes or sections include the triangle, trapezoid and:
Rectangle
The form of a hair design is the result of volume and:
Indentation
The five wet-setting procedures include, distribute, mold, scale, part and:
Apply
What part of a curl is positioned around the roller, thermal iron or round brush?
Circle
The two areas of hair design services are:
Wet Design and Thermal Design
The finishing procedure that reinforces the established lines of the design is known as:
Dry Molding
Hair design analysis includes which of the following levels of observation?
Basic, Detail, Abstract
The size of the whole curl will be determined by the:
Diameter of the tool
Using one or two cushion brushes and brushing all the way to the scalp to integrate the bases when finishing the hair is called:
Relaxing the set
During which of the following levels of observation should you consider the three-dimensional form from all directions, determining where volume (mass or fullness) and indentation (hollowness) are positioned?
Basic
Which type of bristles are recommended for hair brushes?
Natural
When the tool sits in the lower portion of the base, but not on or below the parting, which tool position is being used?
Underdirected