Tools
When work is being performed overhead, tools not in use shall be________
secured or placed in holders.
What is the Minimum Clearance Distance from an Energized Overhead Electrical Line up to 50 kV.
A. - 10 ft B. - 25 ft C. 100 ft
A. - 10 ft
This will be installed on any hole 2 in (5.1 cm) or more in its least dimension on walking/working surfaces such as floors, roofs or other openings.
What are covers.
All flag persons shall wear _______ apparel in accordance with Section 05.F, safety-toed footwear and hard hats
high-visibility
Hand and power tools shall be used, inspected, and maintained in accordance with the ___________
manufacturer's instructions
All equipment and circuits to be worked on shall be _________ before work is started.
de-energized
This shall be maintained at all times when ascending and descending ladders.
What is Three Points of Contact.
High voltage: is a voltage of ______ volts or greater.
600 volts
Hand and power tools shall be inspected, tested, and determined to be ____________ before use
in safe operating condition
This shall be attached to the same location, if possible, that the lock would have been attached. If this is not possible then it shall be attached as close as safely possible to the device and in a position that will be immediately obvious to anyone attempting to operate the device.
What is a Tag.
These shall be self-closing and self-locking, capable of being opened only by at least two consecutive deliberate actions.
What are Snap Hook and Carabiners.
A _______ and ________ should be worn for all tree maintenance and removal operations.
hardhat and eye protection
Power tools designed to accommodate guards shall be equipped with such guards. All guards must be __________
functional
This item passing through work areas shall be protected from damage (including that caused by foot traffic, vehicles, sharp corners, protections, and pinching).
What are extension cords or portable flexible power cords.
This shall be equipped with Suspension Trauma Preventers such as stirrups, relief steps, or similar in order to provide short-term relief from the effects of orthostatic intolerance.
What is a Full Body Harnesses.
This must deliver at least 0.4 gal (1.5 L) of water per minute for fifteen (15) minutes or more (minimum 6 gallons (22.7 L) water).
What is the emergency eyewash.
Only ________ tools shall be used in locations where sources of ignition may cause a fire or explosion.
Non-sparking
Electrical work shall be performed by a ________ ________ with verifiable credentials who are familiar with applicable code requirements
Qualified Person
hot riveting, welding, burning, abrasive blasting, or other fire- or spark-producing operations.
Hot work
______ ______ _______ shall be provided at all burning and grinding operations.
Eye wash facilities