Chapter 1
Describe OSHA safety color code Black and White meaning.
What is Designates traffic and housekeeping areas.
What are four proper ladder safety precautions?
What is Never use a ladder as a substitute for scaffold planks or for horizontal work.
Never use metal ladders near electrical circuits or lines.
What part of an angle is called the vertex?
What is The point where an angle's lines meet.
A ___ hammer is a striking tool with a head made of steel pellets encased in a plastic coating.
What is a Dead Blow
What are the 3 proper safety protocols for preparing to operate a power tool?
Store power tools in a way that protects them from dampness and dirt and reduces the risk of damage to the tools.
To determine the approximate noise reduction of an ear protection device on the job, subtract __ dB from its noise reduction rating
What is seven
What are the characteristics of a wood ladder
What is coated with shellac or linseed oil
When placing a tripod in the desired position, extend the legs and spread them about ____ apart. On sloping ground place ____ of the tripod onto the slope for stability.
What is 3' and 1 leg
A ___ punch is a hand tool with a blunt, circular end that is used to punch small holes in light-gauge metal.
What is soild
What is the purpose of Alternating Current?
What is Voltage in a circuit that has current that reverses its direction of flow in regular intervals.
Describe OSHA safety color code Purple meaning.
What is Designates radiation hazards; used in combination with yellow for markers such as tags, labels, signs, etc.
What is 4:1 and 75 degrees
What is the purpose of a Caliper?
What is a precision measurement tool for inside diameter (ID), outside diameter (OD), and leangth measurement on components
A ___ file is an all-purpose, single-cut file especially adapted for finish filing.
What is a mill
A(n) ___ is a spiral groove that runs along the length of a drill bit.
What is flute
All current ___ standards are reproduced annually in the Code of Federal Regulations
What is OSHA
What is fall arrest system and 6'
A(n) ___ is a measuring tool that folds and is used when working with 45° elbows.
What is Plumber rule
___ pliers are used to grip fasteners and small parts in tight areas and bend and cut wire.
What is long nose
A(n) ___ drill bit is a drill bit used to bore deep holes in wood up to 1'' in diameter.
What is auger
What is Shock
A ___ is an extension ladder accessory that supports a plank to be used for scaffolding.
What is Ladder Jack
A(n) ___ is a parallel line at a known distance to the object line.
What is Offset
___ are used to cut workpieces such as metal pipe, PVC pipe, conduit, all thread rods, rigid plastics, bolts, and nails.
What is a hacksaw
___ wheels produce dangerously sharp edges and leave the metal hot enough to cause burns.
What is abrasive wheel