This type of valve uses an electrical signal to open
What is a solenoid valve?
277 Volts is the reading when measuring line to ground on this nominal voltage
What is 480 Volts?
0670 is the passcode for service mode with a serial number ending in this
What is 7006?
This chemical can be injected during the thermal rinse phase
What is Lubricant?
This component is used to measure temperature... I couldn't resist
What is an RTD (resistive thermal device)?
Open is the normal position for this valve
What is a drain valve?
This type of Controller (CPU) is used on the AMSCO 5052/7053
What is a Kodiak?
This component prevents the drying heater from getting wet during water recirculation
What is the Drying Diverter Piston?
Low and High are the settings for this final phase component
What are drying heaters?
This is the high point value during the resistor kit method of RTD Calibration
What is 212F?
Pressure switches are how this washer measures water level
What is AMSCO 5052 OR 7053?
What are the two possible options for heating the sump?
What are steam and electrically heated?
This chemical is injected by chemical pump #1 (red line)
What is Enymatic Cleaner?
This phase's time, can NOT be set below 1 minute
What is thermal rinse?
The safety level switch circuit is powered through this output on a Vision SC Washer
What is the Drain Valve?
This optional component, reclaims rinse water for use in the next cycle on an AMSCO 7052/7053HP
This component uses 3 contactors to function
What is the Recirculation Pump?
This valve is used to fill the sump on a safety level test in supervisor mode on AMSCO 5052/7053
What is the drain cooling valve?
This phase can be heated, or non-heated
What is the Wash Phase?
Where can you find troubleshooting steps and techniques?
What is EPIKS?
This deceiving valve, doesn't actually go directly to the drain
What is the Drain Cooling Valve?
On AMSCO 5052/7053HP washers, this component isolates supply power to all outputs
What is the Emergency Stop?
This components is used to protect electric heaters
What is Over Temperature Switch (or Thermodisk)?
What cycle should be run at least weekly by the operators?
What is Decontamination Cycle?
This component will fly straight to the top of the chamber if a cycle is ran without a rack present
What is a sliding inlet?