RANDOM
NAI
WAI
HSDI
ICE MODES
100

Where is the wing inspection light located?

On the lower left side of the fuselage aft of the passenger door

100

Limitations of the NAI system while on the ground 

The OAT less than 10c with presence visible moisture in the air

100

What type of tubes is arranged for hot bleed air to be discharged?

Piccolo tubes

100

How many seconds does the inflation cycle for?

6 seconds

100

ICE Mode 2

What is the WAI has failed?

200

After a maximum of ____ seconds of an ID no longer detects ice, the cyan ICE caption is removed.

60 seconds

200

Which mode can you not operate the NAI?

QPM

200

WAI System only activates during this time?

WOW - Weight Off Wheels 
200

How many seconds for the deflation cycle?

54 seconds

200

In ICE mode 1 is latched for how many seconds?

70 seconds

300

Maximum flap extension in icing conditions?

15 degrees of flaps

300

What type of bleed air is supplied via duct that is routed and attached to the right side of each engine?

What is high pressure?

300

The system is inhibited when the TAT is higher than?

15C

300

When can the HSDI system operate? 

It is permitted both on the ground and in flight

300

ICE Mode overrides

ICE mode 2 to 1 and 1 to zero

400

How many seconds does the WS EMER PWR provide heat the windshield for?

60 seconds

400

When does the amber CAS message "IPS ON-TAT Limit" triggered?

When the TAT is more than 10C and the NAI system should be switched off, unless there is an icing environment in which case, continue to use NAI.

400

Why is the WAI system inhibited on the ground?

To prevent overheating of the wing leading edge when there is no airflow over it.

400

When does the amber CAS message "IPS ON-TAT Limit" triggered?

When the HSDI is operating with a TAT below -40C.

400

What happens when either ice detection is triggered? 

The stall warning and stick pusher system is also signaled to operate based on an adjusted datum shifting the stall warning and pusher activation threshold. 

M
e
n
u