Blunt Cuts
Styling
Layers
Hair
Miscellaneous
100
A blunt cut is __________
One Length
100
When performing flat iron pressing, divide the hair into ________ sections
Four
100
A _______ _________ cut is achieved by cutting the hair at 180-degree elevation.
long layered
100
Men's haircuts are more ________ than women's.
angular
100
_______ salons maintain a fairly equal ratio of male to female clientele.
Unisex
200
The most common elevation for the ___________ cut is 45 degrees
Graduated
200
When performing hair molding, mousse and leave-in thermal styling spray are used after shampooing and _________.
towel-blotting
200
When creating uniform layers, establish an interior guide first, then set a guide at the ________.
perimeter
200
__________, _________, & _________ hair will graduate the most with a graduated cut.
Coarse, Curly, & Thick
200
All of the following are techniques for styling women's hair except ___________. Pin curls thermal styling blunt cut hair wrapping
Blunt Cut
300
Cut with uniform __________ to ___________ tension when creating a blunt cut.
minimal to moderate
300
When performing blow-dry styling, beginning in the nap area, insert the brush at the ________ of the section.
Base
300
In a uniform layered cut, all of the hair strands are cut _________ at a 90-degree projection.
to the same length
300
With short natural cuts on ________ ________ hair, the hair is tapered at the perimeter.
extremely curly
300
Cross-checking involves checking for precision of _______ of _________.
line of blending.
400
In a blunt cut, for the ____________ design line, front guide length should be longer than back guide length.
diagonal forward
400
When performing thermal waving, the projection of the hair from the scalp determines the _________ of the curl.
volume
400
Point cutting is perform at the ends of the hair using the _____ _____ _____ ______ at a steep shear angle in relation to the hair parting.
tips of the shears
400
_______-_________ means that the hair is combed away from its natural fall position.
Over-direction
400
A soft press removes ____ to _____ percent of the curl.
50 to 60
500
For the blunt cut, comb the hair and part off into four sections from ______ to _______ and _______ to _______.
front to nape, and ear to ear.
500
Hair wrapping is a styling method that uses ________ as a form or tool.
the client's head
500
When creating a uniformed layer cut, long hair should be parted off into five sections: _______, _______ ______, and _______ _______ panels.
top, two sides, and two back
500
When cutting curly hair, cutting just ______ & ______ the _______ of the _______.
just after & before the crest of the wave.
500
When flat ironing, use a piece of misted tissue paper to ________________.
test the temperature.
M
e
n
u