Hand Tool ID
The screwdriver with a cross shape.
This goes on your eyes when we are working in the shop.
What are safety Glasses?
Everything you make should have one of these.
What is a drawing?
What is a plan of procedure?
The species of wood you used to create the mantel clock
What is red oak?
The machine that uses focused light to either etch or cut wood.
What is the laser machine?
What you would use to remove glue after a glueup.
What is a glue scraper?
Margin of safety at the miter saw.
What is 6"
The number that determines the roughness of sandpaper.
What is grit?
The direction you sand.
What is with the grain?
The machine that drills an angled hole for a Kreg screw.
What is a pocket hole machine?
Name of the bessey clamps that are red.
What is a parallel jaw clamp?
Height of blade above material at table saw.
What is 1/4"
The smallest measured lines on the Milwaukee tape measure.
What is 1/16"
The place you put tools and materials when you are done with them.
What is away?
This machine is only used to cut lumber across the grain.
What is a Mitersaw?
Name of the tool that has an adjustable blade used to check for square as well as 45 degrees?
What is a combination square?
What you do when a piece of machinery is not sounding or acting in a normal manor.
Notify the instructor.
How many times you should measure things before you perform an operation.
What is at least twice?
We put this on clamps to protect the bars from glue.
What is masking tape?
This is a machine that cuts different profiles, edges, slots into wood.
What is a router?
Hammer filled with shot to prevent rebound.
What is a dead blow hammer?
The tool used when your fingers will be too close to a tool.
What is a pushblock, or pushstick?
The number of 1/16" that make up 2"
What is 32?
The lines that run through wood.
What is grain?
This machine is considered the heart of any shop due to its versatilely.
What is the Table Saw?