Measuring Nearest 1/8in
It is the fractional inch halfway between 1/4 inch and 1/2 inch when measured to the nearest eighth.
What is 3/8 inch?
You should wear these when using a drill press.
What are safety glasses or a hair tie?
It is the main advantage over a corded drill.
What is cordless or mobility?
Doing this minimizes kickbacks.
What is keeping materials flat on the table and against the fence?
It is the safest place to place your hands on a piece while cutting.
What is on the sides of the blade or material?
It is the correct symbol or way to mark where you want to draw the cut line.
What is a carrot?
To keep your piece from moving, you should always do this.
What is use a clamp or fence?
It is the best drill bit for driving wood screws to avoid cam out.
What is torx or star bit?
It is a type of cut used when a tight curve is needed.
What is a relief cut?
It is the measured width of 2 pieces of 2x4 that are glued edge grain to edge grain?
What is 7 inches?
It is the most common reason a drill bit will break.
What is use a dull bit?
It is the part of the drill that keeps you from driving bits too deep.
What is the clutch?
Checking for these 2 two things on your material helps ensure a safe miter saw cut.
What are knots and broken boards or splits?
It refers to the rounded, advertised, or standard name/size of a board.
What is nominal?
You should use a low speed when using this.
What is a large bit?
A type of cut that is angled across the side grain of a board.
What is a bevel cut?
It the name used when the blade wanders.
What is blade drift?
What are the jaws of the drill press?
It is one way to remove a stripped screw with a cordless drill.
You should make sure this equipment is turned on before using the miter saw.
What is the dust collector?
It causes blade drift.
What is a dull blade? Wheel alignment or improper blade clearance.