Saws
Saw that runs with the grain and has large teeth and no support piece
What is a Rip Saw?
Has a metal head, used for striking nails, with a claws to remove nails
What is a Clawfoot Hammer?
Made of an inclined plane around a cylindrical shaft with a conic point at the end. The bit can be used to make holes bigger as well as drill new holes. Wood is filtered up through the bit
What is a Twist Bit?
Ruler at a 90 degree angle. Used to measure right angles, straight edges, and marking scrap material
What is a Carpenter's Square?
A high grit of sandpaper makes
What is finer sanding?
Saw that runs through the grain with small, knife-like teeth and a support piece along the top
What is a Crosscut Saw?
Used to strike a chisel, wooden dowels into a piece, or two wooden pieces together with the risk of denting the wood
What is a Wooden Mallet?
Drill bit with a centering point that must be in contact with material when making holes. It can be used in a drill press or hand drill, but cannot make holes bigger cleanly
What is a Forstner Bit?
Multipurpose tool, can be used as a straight edge, to find major degrees: 45, 90, and 180, finds the center of a circle if needed, and has a level
What is a Combination Square (tri-square)
Used with a wooden mallet for detailed work, chipping, splitting or prying two glued parts away from each other
What is a Chisel?
Saw that has small teeth, meant to cut soft metals, and needs to be checked before use
What is a Hacksaw?
Used to fit pieces of wood together or loosen tight fittings on handles
What is a Rubber Mallet?
Centering hole with a paddle-like shape. Center must be in contact with the material, and you cannot cleanly enlarge the hole. Tear out is very prominent
What is a Spade Bit
Accurately marks 90 and 45 degrees, commonly used to mark angles and used as a straight edge
What is a Speed Square? (rafter square)
BONUS: The most important rule of the shop
DON'T BE STUPID!!!
Manual scroll saw that makes fine, detailed cuts, the blade can be removed and needs to be checked before use
What is a Coping Saw?
Used to prevent damages to soft surfaces or have no reverberation
What is a Dead Blow Hammer?
Used only on the drill press to cut large holes, needs pins to be pushed in to avoid locking onto the mandrel
What is Cup Saw?
Used to check if an object is circular, find the center of a circle, or bisecting a circle. Can also be used as a straight edge
What is a Centering Square?
Used in place of sandpaper to help smooth/scrape an edge. Can be used on metal and wood.
What is a File?