safety
What should you wear on your feet in the workshop?
Closed in shoes.
What is a screwdriver used for?
Turning screws.
What tool would you use to measure the length of timber?
A ruler/tape measure.
What is a drill press used for?
Drilling holes in materials.
What is the main reason for having rules in the workshop?
To keep everyone safe.
What must you do before using any tool or machine?
Get teacher permission/check safety instructions.
What simple tool would you use to cut wood?
A Saw
What is the smallest unit shown on a standard metric ruler?
Millimetre (mm).
Why must you remove loose clothing before using machines?
To prevent it catching in moving parts.
What should you do if you see a spill on the workshop floor?
Report it and clean it up immediately.
Why is it important to tie back long hair in the workshop?
To prevent it from getting caught in tools/machines.
What's the difference between a claw hammer and a mallet?
Claw hammer is for nails and pulling nails out; mallet is for tapping without damaging surfaces.
How do you ensure your measurements are accurate when marking out material?
Double-check measurements and mark clearly.
What safety rule applies before starting any machine?
Always check guards are in place and get teacher permission.
Name one material commonly used in Year 7-8 tech projects.
Wood
List two reasons why you should never run in the workshop.
You might trip over tools, or bump into someone using dangerous equipment.
Why should you check the condition of a tool before using it?
To make sure it's safe and not damaged, which could cause injury.
If you need to measure angles, which tool would you use?
Protractor.
Why should you never touch the material while a machine is running?
It can cause injury if your hand slips or the machine catches.
What is a prototype and why is it useful?
A first model made to test an idea/materials before final production.
When using chemicals in the workshop, name two safety items you should use.
Safety goggles and gloves.
Name a tool used for shaping metal and explain how it's used.
File – used to smooth or shape metal edges after cutting.
When marking out for drilling, why is it important to find the centre of a hole?
For accuracy; ensures the hole is in the correct spot and reduces mistakes.
What is one way to check that a machine has fully stopped before removing your work?
Wait for all moving parts to stop spinning before reaching in.
Explain the difference between renewable and non-renewable materials.
Renewable materials can be replaced naturally; non-renewable will eventually run out.