Aircraft Drawings
Which of the following types of drawings will show the flow of fluids in a system?
Electrical schematic
Interconnect diagram
Mechanical schematic diagram
Mechanical schematic diagram
Flammable materials should be stored in:
An OSHA approved area
What type of tap is used to start threads in a hole or to tap through a hole?
A taper tap
This type of drawing is often used in the IPC (illustrated parts catalog).
Exploded views
Why did the bicycle fall over?
Because it was two tired.
Which of the following types of drawings shows the exact size and shape of all parts of complex objects?
Orthographic drawing
Perspective drawing
Isometric drawing
Orthographic drawing
AN 3H-4A means:
Army-Navy 3/16 in. dia., drilled head cadmium plated, ½ in. length non-drilled thread bolt
To size a hole to the final exact dimension: a what is used?
A reamer is used
Electrical wire sizes will be found in which of the following?
A wiring diagram
Where was King David’s temple located?
Beside his ear.
This type of line is used to represent an edge or object not visible to the viewer.
Hidden line
A class three bolt thread has a ______ fit:
Medium
What tool is used to clean a file?
A file card
Schematic drawings are used for which of the following?
Trouble-shooting the system
Why do seagulls fly over the sea?
If they flew over the bay, they would be bagels.
Station numbering means?
A specific measured distance from the datum to a point in or on the aircraft
What type of rivet is used when access to one side of an aircraft structure is extremely difficult or impossible to obtain?
Blind rivet
Torque values can be found in:
The maintenance manual only
The AC43.13-1B only
Both publications listed above
3
Almost all objects are made up of one or a combination of shapes, which are
Triangle, circle, cube, cylinder, cone and sphere
What happened when the lady backed into an airplane propeller?
DISASTER!
“Tolerance” is:
The acceptable variation from the specific dimension given on a print or drawing
A fiber-type lock nut is held firmly on the threads of a bolt by pressure caused by:
The use of an unthreaded fiber locking insert
Which type of pliers should NOT be used to hold or grip objects?
Slip joint pliers
Diagonal cutting pliers
long nose or duck bill pliers
Diagonal cutting pliers
Regarding an orthographic projection, the one-view, two-view, and the three-view are the most common, but; it can have as many as:
6 views
The Wrong Brothers.