TAIJON WAKE UP
A connection made from the PV System to the Utility on the line-side of the main disconnect is referred to as this
Supply-Side
Solar Modules produce this type of currents
DC
A great use for a ground mounted array is to construct them to be used as this.
Covered Vehicle Parking Area
Fossil Fuels, Energy Dependence and Environmental concerns are all factors that have had what impact on Photovoltaics
Increased demand and productivity
The maximum dc source current is defined by NEC® 690.8(A) as the sum of parallel module rated short circuit currents multiplied by ____ percent.
125%
Inverters are required to do this when utility power is lost
De-Energize
Solar Modules that are also used as the outer finish of a building
Building Integrated Photovoltaic Systems
These are the two types of conductors allowed to be exposed for PV installations
P wire and USE-2
Along with Anti-Islanding, another requirement of UL1741 is that the inveters must have this.
Ground Fault Detection Interruption
Ampacity correction for conductors must be used for what type(s) of voltages
AC and DC
Grounding is can be done anywhere in the PV system, but is usually done at which point.
The Inverter
Most residential PV systems are made up of this strings that can be combined in a single box
3-6
Grounded circuit conductors, whether AC or DC must be identified with what two colors
White or Gray
A disconnect is require for what type of conductors before entering the dwelling
DC ungrounded conductors
If addtional grounding electrodes are installed, it shall be connected to this.
The array frame or structure
To meet listing requirements, an Inverter is required to be interrupt outgoing power in the event of a loss of utility power, this is reffered to as this
Anti-Islanding
These two components are needed to ensure proper grounding of an array
Connection Hardware and Aluminum Frames
PV systems that operate independently of a utiity connection are known as this.
Stand Alone System
This is required on buildings, used to easily disconnect power to protect first responders and personnel from shock hazards
Rapid Shutdown
A multiplier is used to determine the maximum current output, a second multiplier is them used to determine these system components
Conductors and Overcurrent Protection
Information about the number, size, and value of panels, locations of disconnects and inverters, and system components
Single Line Diagram
The most common material that Modules are made out of today
Crystaline Silicon
PV Systems that operate with and can feed back into the utility grid are known as this
Utility Interactive Systems
NEC® 705.10 requires that these, that indicates all interconnected power sources for the premises be installed at the service and the location(s) of the power production source(s)
Permanent Plaque or Directory
This is not required is the PV components were sized using 690.8(B)
Overcurrent Protection