Policy Review:
MOC
MOC
when do you need to fill out IOGPs / Start work checks
before starting work
The type of thread on the DP & HWDP.
Delta 391
yesterdays drill was?
natural gas
The size of 272's drill line
1 3/8" diameter
When would a Subject Matter Expert be used help review or plan a JMR?
Subject Matter Experts (SME) may be chosen to give input and help the Senior Technical Manager (STM) make decision, but are not mandatory.
according to Patterson's wind chill chart what needs to be done in the GREY ZONE ?
Take regular, sufficient breaks every 30 minutes in warming areas. Wind chill is monitored each hour and documented.
Today's Patterson UTI Core Value
safety and environment
Name the BOP stack components in order, top to bottom
Annular, blinds, upper rams, mud cross, lower rams
Using the Jobsite Modification Matrix, determine the JMR Category and Approver for a modification that would cost an estimated $50,000.
Approver: VP Technical Services
what must be in place for a vehicle 1 ton or greater?
wheel chocks
what is Chevron's tenet of the day?
9.Follow written procedures for high risk or unusual situations
The Rated Pressure/Maximum Allowable Working Pressure (MAWP) and the Working Pressure of the annular are:
Rated Pressure/Maximum Allowable Working Pressure (MAWP) is 5000 psi (initially tested to 5000, subsequently test to 3500 psi). The Working Pressure range is 700-1500 psi (depending on tubular size).
What are the different types of respiratory protection available at Patterson-UTI worksites?
n-95 respirator, air- purifying respirator, self-contained breathing apparatus, rescue pack.
These are the rig's pneumatic system & hydraulic system pressures
Pneumatic: 120 psi, Hydraulic 2800-3000 psi
When Bringing pumps up to speed ( BPUTS) what Pressure do you hold constant?
C) shut in casing pressure (SICP)
This city is known as the energy capital of the world
Houston, TX
(Tulsa, OK is known as the oil capital of the world)
what start work check (IOGP) should be reviewed & filled out, prior to using the hook under the boom of the fork lift?
Mechanical lifting
what type of cord does a power tool need to be used on location?
three-wire grounding cord or be marked as double insulated.
Why do you use a diverter?
to direct fluids away from rig floor.
TFA means...
Total Flow Area
(the total amount of fluid flowing through the nozzles)